These hinges are made of metal.

Hinge leaves fit into two cutouts (mortises) to mount flush with the door and frame.

Also known as bullet hinges, these hinges are the right size for tight spaces and narrow frames.

These hinges are made of metal.

The hinge pin is permanently attached to the frame leaf so you can quickly lift the door off the hinge without removing the pin.

No separate hinges are required, these supports act as a hinge and lid support all in one. Springs provide lifting assistance to raise and hold lids open—slightly lift the lid to get it started and the support will do the rest. Manually shut the lids and the supports will hold them in the closed position.

Keep environments free of contaminants—with plastic bushings, there's no metal-to-metal contact that can release particles as these supports open and close. Manually control these free-moving lid supports through their full range of motion. Raise the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid.

Manually control these standard free-moving lid supports through their full range of motion. Raise or lower the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid.

Commonly used on hood and trunk lids, these simple, three-piece rods telescope from 18 1/2" to 46 3/4" to prop lids open at a variety of angles.

Providing constant resistance through the full range of motion, these supports hold lids open at any angle up to 70° or 90°.