Made of stainless steel, these carriages and guide rails are more corrosion resistant than steel carriages and guide rails.

Made of stainless steel, these carriages and guide rails are more corrosion resistant than steel carriages and guide rails.

Suitable for clean room use, these carriages and guide rails are made entirely of stainless steel.

Designed for use on horizontal surfaces, the contact angle of the ball bearings on the rail allows these carriages to last longer than other carriages.

Adapt most 15 mm guide rails to fit on T-slotted assemblies.

With a wide base and low-profile design, these carriages and guide rails stabilize moment (twisting) and off-center loads better than other carriages and rails. They're good for use in areas where multiple carriages or rails won't fit.

Mount to vertical surfaces for applications where tight tolerances aren't required.

A handle on the side of the carriage locks the carriage in place.

With a wide base, these sleeve bearing carriages stabilize moment (twisting) and off-center loads better than standard carriages. Use in areas where multiple carriages or rails won't fit.

For applications with low clearance, these carriages protrude less than 5 mm above their rails.

Threaded inserts secure the bearing to the carriage and prevent it from loosening due to frequent starts and stops.

Threaded inserts secure the bearing to the carriage and prevent it from loosening due to frequent starts and stops.

C-shaped guide rails grip the carriage around the outside to support linear motion along walls and other vertical surfaces.

These track roller carriages and guide rails are stainless steel for use in wet, corrosive environments.

Use these carriages and guide rails for light loads where precise movement is not required.

Needle-roller bearings give these track roller carriages higher load capacities than other track roller carriages.

Nylon rollers provide low-friction movement for light loads and corrosive environments.

Combine with a T-slotted rail to add linear motion to your assembly.

Nylon rollers and aluminum rails make these good for light duty applications.

With a row of crossed-roller bearings on each side of the rail, these slides have over twice the load capacity of standard low-friction slides and are better for handling shock loads.

Create your own positioning table or telescoping slide. Sets include four rails, two roller bearing cages, and eight end stops.

A linear scale and micrometer-like hand wheel measure travel distance in increments of 0.001".

A thumb screw locks the slide to prevent movement in systems where vibration is present.

Two micrometer handles ensure accurate, repeatable positioning along two axes—good for positioning parts, such as measuring and inspecting equipment, that are part of a larger automated system.

Three micrometer handles ensure accurate, repeatable positioning along three axes—good for positioning parts, such as measuring and inspecting equipment, that are part of a larger automated system.

At approximately one-third the height of standard versions, these rails provide linear shaft support in applications with low vertical clearance. They provide stability over the entire length of shaft, allow virtually unlimited travel lengths, and eliminate bending under moderate to heavy loads.

Replace worn shafts in two-piece support-rail shaft systems, or mate with a support rail to create your own. The tapped mounting holes match those on our Support Rails.

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.