Turn the handle to move the jaw on these basic vises.

Use the adjustment dials to ensure your work is accurately positioned on X and Y axes.

Tilt and lock the vise to hold work at any angle up to 90°.

Made from unhardened aluminum or steel, machine these jaws to fit the contours and curves of your workpiece.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

Hold workpieces steady with these vise jaws—they work with slot-mount workstops so you can quickly position, adjust, and change out your workpieces.

Quickly move parallels in and out of these jaws to raise your workpiece within the vise. Mount jaws to the vise, slide the mating parallels in place, and rest your workpiece on top.

Replace worn, broken, or lost handles.

Mount to a machine table to rotate a vise 360° in 1° increments.

The small size allows multiple vises to be mounted on a single machine table. Frequently used in 4- and 5-axis milling machines, these vises have stepped jaws with serrated teeth that firmly grip just a small portion of your workpiece.

Designed to hold your part on 4- and 5-axis milling machines, these vises provide rigid clamping while exposing five full sides of the workpiece. This allows even complex parts to be completed in a single operation. You must cut a dovetail into your material before the vise can grip it.

Reliably hold workpieces with these basic machine vises.

The jaws move inward at the same time to consistently position your workpiece in the center of the vise.

Mount these workstops into slotted vise jaws—they hold workpieces in place and prevent horizontal movement during machining.

To grind, drill, lightly mill, and machine parts that rotate around an axis, these chucks hold parts in place magnetically so you can access their inner and outer diameters.

Use these vises for general purpose workholding.

Hold tiny workpieces in these compact vises.

Rotate the head 360° to use three different vise jaws and lock workpieces in position at 45° intervals.

A bright yellow vise body stands out on the shop floor.

The movable jaw can be repositioned to extend the jaw opening. Pull out the entire sliding section and insert it on the opposite side of the vise.

Replace worn flat and V jaws.

These V-shaped liners hold large round material.

Quickly install and remove the clamp-on base from a benchtop.

Insert these one-piece grooved liners between vise jaws to hold small-diameter material vertically.

Also known as woodworkers' vises, these mount to the underside of your workbench and sit flush with the surface.