Organize small parts and hand tools with these racks, which attach to steel walls, cabinets, and other magnetic surfaces.

Attach these general purpose hooks to steel walls, cabinets, and other magnetic surfaces.

These holders keep steel tools and knives in place magentically.

Ball-and-socket connections allow 360° positioning.

Bend these arms to hold small equipment such as lights and microphones in almost any position.

A magnetic base makes it easy to attach, move, and replace these bumpers on metal surfaces. Use them for guarding, aligning, and positioning parts.

Adjust the flexible arm to nearly any position.

For more versatility than other low-profile holders, this holder has six locations for mounting indicators and accessories, including two mounting holes and four places to mount an indicator lug back with the included thumb screws.

The base is comprised of adjustable magnetic pins which allow it to conform to any shape and grip most metal surfaces.

In addition to protecting magnets and mounting surfaces, a rubber coating gives these magnets a slip-resistant surface.

Many small poles give these magnets shallower, more concentrated magnetic fields that hold especially well on thin material. They resist temperatures up to 180° F.

Ceramic magnets resist demagnetization better than other magnets and are an economical choice. They resist temperatures up to 400° F.

A plastic case protects the mounting surface as well as the magnet.

Rare earth samarium-cobalt offers a balance of strength and temperature resistance.

These discs are made of corrosion-resistant ceramic and bonded with rubber for flexibility.

Unlike other flexible magnets, these resist demagnetizing at temps up to 250° F.

Turn the handle to switch these magnets on and off.

These magnet pairs rotate into multiple positions to orient displays, sensors, and other devices. They have a firm hold at specific angles, but turn easily without detaching.

Keep multiple bundles of wire and cable on separate hooks. The hooks have wide openings to allow access for installation, adjustment, and removal.

Hang cable and other flexible material beneath wire to prevent it from sagging and swaying. To install, hook the two ends of the ring around the wire—no fasteners required.

A versatile solution for temporary hanging of pipe and tubing at work sites as well as anywhere welding and fastening are not possible. Feed material through the strap, then use the D-rings to adjust the hanging height.

Add a hook and loop cable tie to these mounts to secure a bundle.

Mount to a surface and add a cable tie to secure a bundle.

Snap these hooks into track to hang equipment or attach straps.

Use the split in the hook to slide a loop on and off these fittings.

Create a tie down by attaching these hooks to elastic strap.

The thick wire coil on these hooks makes them stronger than standard hooks.

Attach a rope to the ring on the pin for remote release where access in limited. These shackles have an eye end for connecting to a hook.

Disconnect by pulling the lever or attach rope to the eye on the lever for remote release.

Lock wrenches into these racks before taking them with you. Snap tools into the slots and twist one wrench to lock or unlock the whole set.

Mount to walls, cabinets, and other steel surfaces.

Lift your tool until the cable retracts into the housing.

18-8 stainless steel anchors have good chemical resistance.

18-8 stainless steel anchors have good chemical resistance.