Ceramic magnets resist demagnetization better than other magnets and are an economical choice. They resist temperatures up to 400° F.

Cover these unfinished magnets with your choice of coating to prevent corrosion.

Many small poles give these magnets shallower, more concentrated magnetic fields that hold especially well on thin material. They resist temperatures up to 180° F.

Made of neodymium, these rare earth magnets are the strongest for their size. Slide onto a rod or use a bolt or screw to install.

Press these magnets into place, or use them like a tongue and groove to align components. The stepped profile allows you to install them without adhesives or screws.

A rubber cover protects the mounting surface as well as the magnet.

A rubber cover protects the magnet and mounting surface.

A plastic case protects the mounting surface as well as the magnet.

Stretch these magnetic strips over corners and irregular surfaces.

Unlike other flexible magnets, these resist demagnetizing at temps up to 250° F.

Position the face of these magnets in direct contact with a flat metal surface and turn on the power to create a magnetic hold.

Plug in these electromagnets to create a magnetic hold. A transformer in the plug converts power from AC to DC, so no additional wiring or power source is needed.

Replace individual rods in an existing filter or create a custom filter.

The guide rods direct flow to the magnetic rods. They’re helpful in removing dry particles from fine powder and low-flow applications.

Pull the rods from their sleeve to release particles stuck to the filter.

Coated with PTFE, these stirring bars are corrosion and chemical resistant.

One of the most machinable types of stainless steel available, 416 contains sulfur for fast machining without clogging cutting tools. It's used for gears, screws, and shafts.

Often used for fasteners and valves, 410 stainless steel withstands wear caused by abrasion.

Hardened for superior wear resistance, these rods are precision ground to a tight diameter tolerance so they’re ready for turning in a lathe.

The width and thickness are oversized for finishing to your exact requirements.

Ready for turning in your lathe, these rods are precision ground to a tight tolerance.

Suitable for making molds, 420 stainless steel is a hard, wear-resistant material that can be finely polished to a very smooth surface.

With a higher chromium content than 15-5 PH stainless steel, this high-strength 17-4 PH offers better corrosion resistance. It is also known as 630 stainless steel.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

Hardened for improved strength and wear resistance, these rods are precision ground to a strict diameter tolerance. Use them for turning applications in your lathe.

To attach, slide forks into the forklift pockets and tighten the eyebolts. Lift the top hand lever to release debris.

Run chain through the eyebolts to attach these sweepers to your vehicle. Press the toe plate to release debris.

An extra-long shaft enables access to material in hard-to-reach areas. These retrievers can pick up heavier objects than our other magnetic retrievers.

Pick up screws, nuts, and other small steel objects.

Often used to pick up steel sheets, the magnet holds material until you press the lever to disengage it.

LEDs light the magnetized tip and the shaft bends and stays in position to reach objects in awkward spaces.

Protect against accidental contact with live electrical circuits. These insulated retrievers are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. The shaft bends and stays in position to reach objects in awkward spaces.

The head pivots, so you can pick up screws, nuts, bolts, and other small steel objects from any angle.