Install standard and dual-sided fabric snaps with one push of the handle. Standard snap halves require a 4-piece die set (sold separately) for installation. Dual-sided snap halves require a die (sold separately) for installation.

Removable rotating base-plate press accommodates shafts and arbors with different diameters. For pressing and assembling small parts, this press provides the right amount of force in a compact size. It has an adjustable-length arm to modify leverage.

With the pull of a lever, these presses deliver force for staking, riveting, and removing bearings and arbors. They have an adjustable-length arm to modify leverage. The rotating base plate fits shafts and arbors of different diameters. Also known as arbor presses.

With a high-leverage arm, these presses provide more force with less effort than standard presses. With the pull of a lever, these presses deliver force for staking, riveting, and removing bearings and arbors. The removable rotating base-plate press accommodates shafts and arbors with different diameters. Also known as arbor presses.

Fixed base-plate presses have a flat surface for attaching dies, press-in assemblies, and printed circuit boards. With the pull of a lever, these presses deliver force for staking, riveting, and removing bearings and arbors. They have an adjustable-length arm to modify leverage. Also known as arbor presses.

Removable rotating base-plate presses accommodate shafts and arbors with different diameters. With the pull of a lever, these presses deliver force for staking, riveting, and removing bearings and arbors. They have an adjustable-length arm to modify leverage. Also known as arbor presses.

Attach this press to a wall, sturdy column, or machine side. With the pull of a lever, it delivers force for staking, riveting, and removing bearings and arbors. It has an adjustable-length arm to modify leverage. The rotating base plate to accommodate shafts or arbors with different diameters. Also known as an arbor press.

These presses have a jack mounted on the top cross bar that drives down a press plate instead of a ram. The plate automatically returns after pressing. Raise or lower the table by moving the supports in the vertical uprights.

For applications requiring the greatest force, this press has a hydraulic pump that provides 30,000 lbs. of pressure. With the pull of a lever, it delivers force for staking, riveting, and removing bearings and arbors. Also known as an arbor press. The adjustable safety valve screw lets you set the pressure below the maximum. You can use the two included V-blocks or press plates (sold separately) as a base plate.

Constructed with welded, reinforced steel channel, these presses have up to three times the force of standard hand-operated floor-mount presses. A release valve controls the ram. They have a self-locking hoist to raise and lower the table. Mobil DTE 24 Ultra or equivalent hydraulic oil is required (sold separately).

Install heat-set inserts into plastic with precision. These presses hold the soldering iron straight for consistent installation every time—no misaligned or warped parts. Attach an installation tip, then set the temperature and installation depth. If you remove the tip from the soldering iron and take the iron off the press, it can be used for other soldering tasks.

Lay these heavy duty plates on the crossbeams of your manual or hydraulic press to make a sturdy base for removing bearings, bushings, and arbors. Thicker, wider, and heavier than the cast iron plates found on most presses, these high-strength steel plates handle greater pressing forces and are less prone to chipping, breaking, and shattering. They have round and V-shaped notches on their sides. Place two plates next to each other to create a hole for the bearing, bushing, or arbor to pass through.