Half the height and the same width as regular strut channel, this low-profile strut channel fits into tight spots and is compatible with many of the same brackets.

This welded, one-piece strut channel combines two strut channels back-to-back.

Create continuous runs of channel without corners.

For compatibility with quick-connect clamps to secure pipe and conduit without screws and tools, this strut channel has narrow slotted holes.

Connect two channels to create a stacked channel.

Push these nuts into place rather than threading them onto a fastener.

In addition to serrated grooves for gripping the lip of the channel, these nuts have wings for easy positioning.

A tab fits tightly against the lip of the channel to keep these nuts from slipping.

Insert these nuts into the long open side of strut channel and twist to secure. A built-in washer enables one-handed installation.

Notches on these washers grip the channel to keep them in place.

Keep hardware centered in the strut channel slot.

These brackets have narrow slots compatible with quick-connect clamps for securing pipe and conduit on the channel side of struts without screws or tools.

Push these brackets into strut channel and tighten the included cam screws for a partially concealed connection.

Provide a stable, nonmarring base for strut channel legs.

Create a four-sided raceway for cable, or give a more finished look to strut channel structures.

For quick mounting of components, these hangers snap into strut channels for a strong hold and easy repositioning.

Support the corners of strut channel structures.

Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

Cover rough ends of strut channel.

Hold pipe, tubing, and conduit away from strut channel.

For areas with low clearance, these clamps have the mounting fastener to the side of the material, rather than on top.

Slide multiple clamps into existing strut channel to organize lines of pipe, tubing, and conduit without the need for drilling, welding, or using adhesive. Clamps have a plastic or rubber cushion or body to reduce vibration.

Clip these saddles around the outside of strut channel for a quick way to route insulated tubing and pipe. Lips on either end of the saddle protect insulation from abrasion if the pipe should move.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage.

Adjust supports to the exact height you need to route pipe, conduit, and tubing through strut-mount routing clamps and hangers.