Framed in aluminum T-slotted extrusions, these customizable machine guards provide multiple points of attachment for other components and structures.

Doors have a magnetic latch. They can be mounted to swing open to the left or right.

For technical drawings and 3-D models, click on a part number.

These panels lift on and off their posts in seconds, so you can protect machinery while providing access for maintenance.

When standing on the side of the door that swings away from you, left-hand doors open to the left; right-hand doors open to the right.

The assembled width measures the installed width of a panel or door when mounted with posts on each side.

For added protection around larger machines, choose 8 ft. high posts and 7' 6" high doors. To create taller panels, pair 5' 6" high panels with 2 ft. high panels of the same width and add them to the posts.

Adjustable corner posts have hinges, so you can angle them to create inside corners and other angles along your machine.

For technical drawings and 3-D models, click on a part number.

Maximize safety and minimize machine downtime between processes—these doors stop dangerous machinery from running when they’re open, and close in just seconds with the press of a button. Compared to other machine guard doors, they’re faster, taking only two seconds to raise and lower. They also require less floor space than light curtains because they don’t require safety zones. A safety interlock switch signals your programmable logic controller (PLC) to shut off equipment as soon as the door starts to open. Once the door is fully closed, it sends a signal to restart your machine. They have two photocell sensors for full safety coverage. If interrupted, the door will stop and reverse to the fully open position. Unlike light curtains, these doors function as a physical barrier between hazardous equipment and personnel. They’re made of vinyl fabric to keep projectiles, fluid splatter, sparks, and other machine hazards contained.

Combine these doors with machine guard panels (not included) or install them into an existing system to create a complete barrier around machinery. They have aluminum side frames that mount directly to the floor to keep them anchored in place. You can easily access parts for maintenance by removing the cover on the side panels.

In the event of a power outage, open them manually using a hand crank. These doors are only for use indoors.

Both doors have an 8’ tall opening height to accommodate personnel. Doors with an 8’ opening width can accommodate forklifts.

For technical drawings and 3-D models, click on a part number.

Protect personnel and equipment from flying chips with these portable panels.

Panels with a screen protect against larger chips and allow air to pass through. The reinforced screen panels have a grille that provides more impact resistance than the screen alone. Solid panels provide the most protection.

Mount near a machine to deflect flying chips away from the immediate area. Guards swing in and out as needed and can be locked in any vertical position.

For technical drawings and 3-D models, click on a part number.