Thanks to the nickel-plated brass base on these needles, they can be cleaned, washed, boiled, or sterilized.

Connect these needles to adhesive cartridges, grease guns, and other dispensers with a threaded connection.

Dispense fluid from syringes and other small instruments with luer lock connections.

Transfer liquid from one container to another, without contamination or spilling, by inserting the needle through each lid.

Sterilized so they won’t contaminate your samples or lines, these liquid samplers are often used in food processing, pharmaceutical, and biotech applications.

Connect to Fluke multimeters with a set of red and black test leads.

Pairs of red and black test leads are ready to connect to a multimeter or other electrical test equipment.

Perform electrical tests with a set of red and black test leads and interchangeable tips.

The assorted needle-sharp picks in these sets are similar to dental instruments and suitable for work around delicate circuits and components.

Pierce pliable plastics, rubber, and other soft solids to check the internal temperature.

Remotely monitor the temperature of liquids and gases in hard-to-access, hot, and high-vibration areas.

Safely measure the temperature of liquids and gases wherever flammable gases, dust, and fibers are present.

Measure the temperature of liquids and gases without damaging the probe on these transmitters. An included thermowell shields the probe from vibration, corrosion, and shocks in tanks and pipes.

For easy installation in thermowells, tanks, pipes, and other closed vessels, these thermocouples have an NPT male probe connection.

Thick wire with ceramic insulation stands up to extreme air temperatures in forging, die casting, and heat treating.

A remote probe extends your reach in hard-to-access areas. These thermometers come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

For a longer service life than thermocouple probes and more consistent readings over time, these thermometers have a resistance temperature detector (RTD) probe. They come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

For use in food-processing applications, this thermometer meets NSF/ANSI standards and includes a thermocouple probe with a pointed tip to pierce dense meats and frozen foods.

Designed for clean-in-place applications such as dairy processing and food-preparation areas, these 3-A certified RTDs have a sanitary quick-clamp probe connection for easy removal.

Send temperature readings directly to programmable logic controllers (PLCs)—with a built-in transmitter, these RTDs don’t require a separate signal converter. They’re threaded, so they’re ready to install into containers, tanks, and pipes.

View temperature readings and adjust settings directly on these RTD probe transmitters.

Often used to measure temperature in water lines and low-pressure steam lines, these RTDs have an NPT male probe connection for easy installation in pipes, tanks, and thermowells.

Obtain more precise and reliable liquid and gas temperature measurements than thermocouple probes.