Apply this general purpose tape to any surface that requires traction.

Great for muddy and greasy areas, this tape has an extra-coarse surface for excellent traction.

Stick this ultra-flexible tape to ladder rungs, diamond tread plates, and other uneven and irregular surfaces with sharp corners.

Openings in the surface allow dust, dirt, and liquids to pass through.

Screw nosing into place to protect the front portion of the stair and provide a slip-resistant surface.

Protect stairs from wear or provide a new stair surface on worn stairs.

Often used in stairwells and hallways, these tiles have a raised-disc surface that provides traction and is easy to clean.

These mats provide good traction while protecting walkways, ramps, and other high-traffic areas.

With a coarse ceramic/garnet abrasive surface, these mats feel like walking on sandpaper, even in environments where moisture and grease are constantly present.

Suction cups on the bottom keep these mats in place when wet.

Bunching, creeping, and sliding mats and rugs can be as dangerous as they are annoying. Use underlays to keep them in place.

Encourage social distancing in areas where adhesive floor decals can't be used or where waiting-line locations often change.

Longer-lasting than antislip tape, these coatings contain grit to provide traction. They’re good for areas with pedestrian traffic.

These provide the highest traction and impact resistance of our antislip coatings. Longer-lasting than antislip tape, these coatings contain grit to provide traction.

Use these primers on your surface before antislip coatings to maximize longevity.

Use these primers on concrete floors before antislip coatings to maximize longevity.

Wrap around ladder handrails for a solid grip.

Made of neoprene rubber, these feet are a good choice for use in oily environments.

Great for use outdoors, these feet are EPDM rubber, which withstands exposure to direct sunlight.

Studs dig in and hold tight on icy surfaces.

These boot covers are made of PVC to hold up in wet and oily environments.

Wear over mid-calf and knee-high boots. They protect boots from water, wear, and abrasion.

Taller than shoe covers, boot covers protect mid-calf and knee-high boots. They are lightweight and protect boots from dirt, grime, and liquid splashes.

A green light and a beep alert you when you've reached 90% of your set torque, and a steady tone sounds once you've hit your target. Set your torque in cNm, cm-Kg, or in.-lbs. and quickly check the LCD for real-time measurements along the way. A red light warns if you begin to overtighten.

Reduce slipping and stripping the screw recess. The tip of these drivers has ribbed grooves that grip the surface of the recess, minimizing the pressure required to achieve maximum torque.

Even oily hands can keep a firm grip on the suede-like textured handle.

Ribs forged into the wings of these offset-cross-shaped bits grip the screw recess to reduce stripping. They are also known as ACR® bits.

Sweep, mop, and vacuum over these sorbents, and the adhesive will hold them in place.

Safely clean up fuel and other flammable liquids with these fire-retardant sorbents.