About half the height of standard-profile locknuts, these fit in spaces with low clearance. You can also use them as jam nuts by threading them against a hex nut to hold it in place. The nylon insert grips the screw to prevent loosening from moderate vibration without damaging threads. However, the insert may become brittle if exposed to high temperatures. These locknuts are reusable a handful of times, but the holding power decreases with each use.

A nylon insert grips the screw for a stronger hold than a serrated flange, without damaging threads or marring the surface of your material. However, the insert may become brittle if exposed to high temperatures. These nuts have a flange that distributes pressure evenly across the mounting surface, so you don't need a separate washer. They are ideal for securing screws in oversized or irregularly shaped holes since the flange covers a larger area than standard nuts. You can reuse them a handful of times, but their holding power will decrease with each use. Also known as collar nuts.

To save on assembly time, these locknuts combine a hex nut with a free-spinning lock washer, so you can twist them into place by hand. Once the nut is against your material surface, tighten it down with a wrench or socket to get the teeth to bite. Although these nuts install more quickly than nylon-insert locknuts, they don't hold up as well against vibration and can mar your material. As long as the washer stays intact, you can reuse them. Also known as Keps and K-lock nuts.

Irregularly shaped threads at the top of these locknuts grip the screw for a stronger hold than nylon-insert locknuts. Although the threads prevent the nut from backing out due to vibration, they also increase the effort to install and remove. To get these nuts off, you may need special tools, such as an impact wrench or propane torch. Nuts are not reusable.

The curved, spring-like washer grips surfaces more tightly than tooth-lock washers for better vibration resistance. These locknuts also install just as quickly since you can twist them into place by hand. Once the nut is against your material, tighten it down with a wrench or socket. The washer's smooth edges won't mar the surface like teeth can. As long as the washer stays intact, you can reuse these locknuts.

The top section of these nuts expands to grip the screw on all sides for a stronger hold than both nylon-insert and distorted-thread locknuts. They’re often used in equipment with constant, vigorous vibration, such as engines. These locknuts are reusable a handful of times, but the holding power decreases with each use.