Made from brass, these nuts are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

For technical drawings and 3-D models, click on a part number.

Half as thick as regular hex nuts, these nuts fit into spaces with low height clearances. They are about half as strong as medium-strength steel, and are often used for light duty applications, such as securing access panels. Also known as jam nuts, they can be threaded together to form a locknut that won’t move or loosen due to vibration. When fastening threaded rod, you can use two nuts to create a point for tightening the rod with a wrench. These nuts have less tensile strength than a standard hex nut when used alone.

Steel nuts are best for dry environments, since exposure to moisture and chemicals will cause them to rust.

Zinc-plated steel nuts have an outer layer of zinc that protects the inner steel from rust and extends the life of the nut.

Nuts that meet DIN 936 and ISO 4035 (formerly DIN 439B) adhere to international standards for dimensions and material composition to ensure compatibility with other products and tools. Although the DIN 936 and DIN 439B standards are no longer active, they are commonly referenced globally.

For technical drawings and 3-D models, click on a part number.

Useful in low-clearance applications, these metric nuts are roughly half the height of standard hex nuts, but aren’t as strong. Commonly used as locknuts, threading a thin nut against any other hex nut prevents loosening caused by vibration. You can also use them as jam nuts by threading two of these thin nuts against each other on a threaded rod to create a gripping point for turning the rod without damaging its threads. All are 18-8 stainless steel, which is nearly as strong as steel but won’t rust in outdoor, washdown, and other corrosive environments.

ISO 4035 nuts are functionally the same as DIN 439B nuts (sometimes called DIN 439-2), but have slightly different width tolerances. These nuts have chamfered edges that make them less sharp than DIN 936 nuts.

For technical drawings and 3-D models, click on a part number.

These metric nuts are made of 316 stainless steel and half as tall as regular hex nuts—use them around chemicals and salt water when space is limited. Also known as jam nuts, they can be tightened in pairs to prevent loosening from vibration. Jamming two of these nuts together can also create a gripping point on a threaded rod, letting you use a wrench to turn the rod without damaging the threads.

ISO 4035 (formerly DIN 439B) nuts are chamfered, so their edges are less sharp than DIN 936 nuts. This new ISO standard is functionally the same as the DIN standard it replaced, with slightly different tolerances for width.

For technical drawings and 3-D models, click on a part number.

Made from 18-8 stainless steel, these locknuts have good chemical resistance and may be mildly magnetic. The nylon insert grips the bolt to resist loosening without damaging threads. They're reusable, but their holding power lessens with each use. Metric 18-8 stainless steel is also known as A2 stainless steel.

For technical drawings and 3-D models, click on a part number.

Made from 18-8 stainless steel, these thumb nuts have good chemical resistance and may be mildly magnetic. The flange distributes the load over a large area and reduces stress where the nut meets the material surface. A knurled head provides a slip-resistant grip for controlled adjustment.

For technical drawings and 3-D models, click on a part number.

Use these tools to install press-fit nuts by hand. They include one hand tool, seven hole punches and dies, five fastener anvils, one flat punch, one punch adapter bushing, and one edge-depth guide.