To keep airborne oil and odor out of your work environment, connect these filters to your high-vacuum oil pump. They purify pump exhaust in two stages: a fiberglass layer captures oil and collects it into a drain, and an active carbon layer removes any odor-causing oil or chemical vapors.

Purify exhaust fumes while silencing the noise from your oil-free high-vacuum pumps.

Also known as reclassifiers, these mufflers have a clear reservoir with a drain plug to remove and store oil mist for reuse.

A small hex size makes these high-flow mufflers a great fit for cramped spaces.

With a threaded connection on both ends, these mufflers can be installed anywhere in your line.

Made entirely of stainless steel, these mufflers stand up to harsh, corrosive environments.

Install these mufflers in air-powered drills and other loud equipment. They filter exhaust fumes and reduce noise by 30-35 dB, a reduction that's equivalent to putting in earplugs.

Don’t let an unexpected clog interrupt your work. These mufflers have a filter that slides up slowly as it clogs to indicate when the muffler should be replaced. They reduce noise by 30-35 dB.

Keep moisture, dirt, and debris from entering your oil reservoirs.

Also known as coalescing filters, these filters remove compressor oil to extend the service life of air-powered tools and equipment.

Also known as coalescing filters, these filters remove compressor oil to extend the service life of air-powered tools and equipment.

Also known as coalescing filters, these filters remove compressor oil to extend the service life of air-powered tools and equipment.

Also known as coalescing filters, these filters remove compressor oil to extend the service life of air-powered tools and equipment.

A polyurethane bowl offers good chemical resistance for use with synthetic compressor oils and aggressive cleaning agents.

A sensor in these filters monitors changes in differential pressure and sends an electrical signal to a programmable logic controller (PLC) or other remote location when the filter needs to be replaced.

Eliminate small traces of oil vapor and its associated odor with these filters and then throw them away when you're done.

Use these filters in applications where high-quality air is critical. They remove particles down to 0.003 microns, eliminating small traces of oil vapor and its associated odor.

Replace the filter element in your Norgren modular compressed air filter to trap solid particles and water droplets as small as 5 microns.

Two-stage filtration is like getting two filters in one—the first stage removes large particles, while the second removes fine particles.

Replace a damaged bowl, or change the bowl material or drain type on your ARO modular compressed air filter.

Housing and bowl are 304 stainless steel for good corrosion resistance in damp environments.

Each of these filter/dryers has two desiccant towers—one that absorbs moisture, particles, and oil in the air while the other reactivates saturated desiccant so you have an uninterrupted supply of clean, dry compressed air.

These dryer/filters have a clay desiccant that removes moisture, oil, and particles, so there’s no need to install a separate filter and dryer. Once aftercoolers and separators have removed the bulk of the water, they remove any remaining moisture in your air line.