Use these tools to hold, separate, and position wire, springs, and other small parts.

The handle has a magnet at the end to pick up small steel objects. Use these picks to hold and position wire, springs, and other small parts.

A different tip at each end allows you to install, extract, and position parts with one tool.

Change tips to use a different size or style pick for holding and positioning wire, springs, and other small parts.

Avoid nicking or scratching sensitive components. Also known as spudgers, these picks are good for adjusting small wires or separating press-fit plastic components.

Solder won’t stick to these assorted picks, which are used for positioning circuit board components.

These assorted picks have insulated handles that protect against accidental contact with live electrical circuits. They are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Pull material out of tight spots. Similar to removing a cork from a bottle, the tip twists into material to provide a firm hold while the handle provides the necessary leverage for pulling.

Replace tips when they become worn or to use a different style. The corkscrew tip twists into material to provide a firm hold while the handle provides the necessary leverage for pulling.

Made of beryllium copper that is FM approved, these pullers satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Use to extract material from tight spots.

The assorted needle-sharp picks in these sets are similar to dental instruments and suitable for work around delicate circuits and components.

A different tip at each end installs and positions tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

The assorted picks in these sets are used to install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.