Use the assorted tools in these sets to pull material out of tight spots. The corkscrew tips twist into material for a firm hold while the handle provides the necessary leverage for pulling.

Sets include an assortment of handles and tips for pulling material out of tight spots. Replace tips when they become worn or to use a different style.

Made of beryllium copper with an aluminum-bronze handle, these pullers satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Use to extract material from tight spots.

Use these tools to hold, separate, and position wire, springs, and other small parts.

The handle has a magnet at the end to pick up small steel objects. Use these picks to hold and position wire, springs, and other small parts.

Change tips to use a different size or style pick for holding and positioning wire, springs, and other small parts.

A different tip at each end allows you to install, extract, and position parts with one tool.

Solder won’t stick to these assorted picks, which are used for positioning circuit board components.

These assorted picks have insulated handles that protect against accidental contact with live electrical circuits. They are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Avoid nicking or scratching sensitive components. Also known as spudgers, these picks are good for adjusting small wires or separating press-fit plastic components.

Shaped for removing the seals around bearings, insert the tip of these tools behind the seal and pull. The curved head provides leverage to remove stuck and stubborn material.

Also known as packing irons, the offset handle allows you to install packing into hard-to-reach areas while the blunt tip prevents accidentally cutting or damaging the packing material.

Install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

The assorted needle-sharp picks in these sets are similar to dental instruments and suitable for work around delicate circuits and components.