Hang your HMI in areas with frequent washdowns. Made of 304 stainless steel, these arms resist corrosion from most cleaners and detergents. They’re also gasketed at every joint to seal out moisture. Since they suspend from surfaces, they won’t take up valuable floor space. The joints pivot, so you can position your HMI right where you need it. A brake locks the position in place. Use the locking pins to set how far these arms swing to keep them out of the way. Route wire to and from your HMI through a hole that runs through the entire arm.

These arms are designed to mount to our stainless steel enclosures for positioning arms. A complete arm requires a base, tube, and mount. If you want to mount your arm to a wall or other vertical surface, you’ll need a bracket. Add an adapter if you want to tilt the enclosure. Arms that are 20" long support up to 250 lbs. For each additional inch, load capacity decreases by 2 lbs.