Hang wrenches, handsaws, levels, and other tools on these hooks.

Assortments include enough pieces to set up an entire pegboard.

Assortments include hooks, holders, and bin boxes to organize tools on a pegboard. A locking tab and mounting screw secure each piece on hardboard pegboard.

Hold steel tools, nails, nuts, screws, and other magnetic items on your pegboard.

Organize bottles, cans, and jugs with these holders.

Made of hardboard or plastic, these pegboards are an economical alternative to framed pegboards.

Write notes and reminders on the dry erase board. The frame prevents the pegboard from warping and has hangers on the back for easy installation.

Often used to store long tools such as shovels, these all-metal strips hold up to 1,000 lbs.

Attach the lid to pegboard and then unscrew the jar to grab small parts.

Screw the clip into hardboard pegboard, then add any hangable bin box.

These holders keep steel tools in place magnetically.

Store tools such as shovels and screwdrivers for convenient access.

Unlike most slatwall, this composite-wood slatwall has aluminum channels for increased durability.

Hold large and small tools while keeping them visible.

Use these bins to hold small parts.

Use these metal dowel pins as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

Slip these pins in and out during maintenance or prototyping—they’re undersized to make alignment easier.

Cut this 12" stock to the length you need.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

Center-knurled pins are often used in place of clevis pins or to create T-handles. The knurled center locks pins in position, while the smooth ends act as a pivot.

Grooves hold these pins in place, and a round head gives them a finished appearance.

These pins are commonly used as anchors for tension springs. The grooved half locks pins in position, and spring ends fit in to the notch. Also known as type G pins.

Center-groove pins are often used in place of clevis pins or to create T-handles. The grooved center locks pins in position, while the smooth ends act as a pivot. Also known as type E pins.

To remove these pins, thread a screw or tool into the tapped hole, then pull them out.

A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Use these pins to fasten components made of soft materials such as plastic or aluminum. Opposing barbs bite into each piece, pulling them together for a tight, secure fit.

Hold shelves in cabinets and bookcases without standards.