Mount a length of strut channel between the ends of a beam to run cable and conduit along the beam without drilling.

Securely fasten strut channel to the floor.

Connect two channels to create a stacked channel.

Serrated grooves grip the lip of the channel.

When there's no access to the open side of a strut channel, slip one of these nuts through a slotted hole and turn it 90° to secure it in the channel.

A tab fits tightly against the lip of the channel to keep these nuts from slipping.

In addition to serrated grooves for gripping the lip of the channel, these nuts have wings for easy positioning.

Also known as insert nuts, these convert slotted holes to threaded round holes and keep them centered in the channel.

Use with hex nuts to connect threaded rod.

Add hardware to strut channel without having to hold the washer in place or reach inside the channel.

With welded ends, these short lengths of strut channel provide a finished look when mounting clamps and accessories to machines and surfaces.

Made with a 110° angle and 3-ft. radius, use this curved channel to create continuous runs of channel without corners.

Half the height and the same width as regular strut channel, this low-profile strut channel fits into tight spots and is compatible with many of the same brackets.

Run cable and tubing in the tightest spaces with channel that is one-quarter the height and one-half the width of regular strut channel.

This welded, one-piece strut channel combines two strut channels side-to-side.

Provide smooth motion between two pieces of strut channel.

Brackets mount on the outside of strut channel to allow trolley movement.

A tab on the end of these shelf brackets fits inside the strut channel for extra stability.