Use these tools to hold, separate, and position wire, springs, and other small parts.

A different tip at each end allows you to install, extract, and position parts with one tool.

The handle has a magnet at the end to pick up small steel objects. Use these picks to hold and position wire, springs, and other small parts.

Change tips to use a different size or style pick for holding and positioning wire, springs, and other small parts.

Avoid nicking or scratching sensitive components. Also known as spudgers, these picks are good for adjusting small wires or separating press-fit plastic components.

An insulated handle protects against accidental contact with live electrical circuits. These picks are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Position circuit board components without solder sticking to these picks.

Similar to dental instruments, these needle-sharp picks are suitable for work around delicate circuits and components.

The assorted picks in these sets are used to install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

A different tip at each end installs and positions tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

Pull material out of tight spots. Similar to removing a cork from a bottle, the tip twists into material to provide a firm hold while the handle provides the necessary leverage for pulling.

Sets include an assortment of handles and tips for pulling material out of tight spots. Replace tips when they become worn or to use a different style.

Shaped for removing the seals around bearings, insert the tip of these tools behind the seal and pull. The curved head provides leverage to remove stuck and stubborn material.

Also known as packing irons, the offset handle allows you to install packing into hard-to-reach areas while the blunt tip prevents accidentally cutting or damaging the packing material.

A fluorescent orange handle makes these retrievers stand out, so they’re less likely to be misplaced.

An extra-long shaft enables access to material in hard-to-reach areas. These retrievers can pick up heavier objects than our other magnetic retrievers.

Push the plunger to engage the magnet; release to disengage. These retrievers bend into position and stay in place.

LEDs light the magnetized tip and the shaft bends and stays in position to reach objects in awkward spaces.

An extra-long shaft and pivoting head lets you access hard-to-reach material from almost any angle.

Thin wire jaws grasp small or oddly shaped objects.

An LED lights the wire jaws and the shaft bends to reach objects in awkward spaces.

Spear litter with the sharp point.

Also known as rescue hooks, these retrievers are often used to pull an injured worker away from electrical hazards without risking the safety of other workers. They have a fiberglass handle and insulated hook to protect against accidental contact with live electrical circuits. The handle is tested to meet the requirements of ASTM F711.

Safely push, pull, and clear objects from hard-to-reach places such as conveyors, chutes, and hoppers. With a lightweight handle and plastic head, these removers won’t damage material finishes.

Slip the cable over an object and it locks in place once tightened.

Mark steel and plastics or use as a pick for cleaning and probing.

Mark almost any surface including the hardest tool steel and glass. The diamond tip on this scriber lasts longer than carbide tips on hard materials.

An insulated handle and shaft protects against shock from accidental contact with live electrical circuits. These awls are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Also known as a marking gauge, this scriber draws precise, straight lines without the need for a straightedge or ruler.

Slide these shims between the padlock shackle and body to open most locks that are damaged or missing keys.

Made of aluminum-bronze that is Factory Mutual approved, these pick heads inhibit sparking and are nonmagnetic and corrosion resistant. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Chip and scrape away weld spatter, paint, and rust.