The faceplate is sealed to meet NEMA 4X and IP66 for protection in washdown environments with splashing water, corrosive liquid, and dust. The rear case meets IP20. These controllers have proportional-integral-derivative (PID) software with fuzzy logic that learns system behavior and automatically compensates for changes to achieve high accuracy in applications with fluctuating conditions. They read temperature with a highly sensitive thermocouple probe (sold separately) in critical process applications to turn heating equipment on or off at a specified temperature. All fit into instrument panels with DIN cutouts. Set actuation points with the keypad.

Controllers with automatic reset turn machines back on once the temperature decreases. Controllers with automatic/manual reset give you the choice to have machines turn back on either when the temperature drops or you reset their switch.

Controllers with 1/16 DIN trade size have one alarm relay.

Controllers with 1/8 and 1/4 DIN trade size have two alarm relays.

Mechanical relays actuate one circuit directly. SPDT (Single pole, double throw) relays can be set to turn the circuit from off to on (normally open) or from on to off (normally closed). SPST (Single pole, single throw) relay turns the circuit from off to on (normally open).

Solid-state relays actuate an external relay (not included). They have a longer service life than mechanical or signal relays.

Signal relays output 4-20 mA current to actuate equipment on a current loop.

For technical drawings and 3-D models, click on a part number.

Install these controllers into instrument panels. They read temperature with a highly sensitive thermocouple or RTD probe (sold separately) in critical process applications to turn heating equipment on or off at a specified temperature. Set the actuation point with the keypad. Controllers are SPDT (single pole, double throw). They can be set to turn one circuit from off to on (normally open) or on to off (normally closed).

These lightweight controllers have a carrying handle. They read temperature with a highly sensitive Type J thermocouple probe (sold separately) to turn heating equipment on or off at a specified temperature in critical process applications. Use the keypad to set the actuation point. All controllers are SPST (single pole, single throw). They have a control relay that turns one circuit from off to on (normally open). All come with a flat-pin connector for attaching a thermocouple.

For technical drawings and 3-D models, click on a part number.

For protection in washdown conditions with splashing water, corrosive liquid, and dust, these controllers have a housing that meets NEMA 4X. They include a highly sensitive Type J thermocouple to take temperature readings in critical process applications and have a single primary output to turn heating or cooling equipment on or off at a specified temperature. Use the keypad to set the actuation point. Controllers are 3PST (triple pole, single throw). All have a control relay that turns three circuits from off to on (normally open). They also have two alarm relays.