Pivots provide smooth motion at the junction between two T-slotted rails.

Attach and position phones, tablets, monitors, and other displays on T-slotted rails.

These steel rod ends are machined to SAE standards.

In addition to offering superior chemical resistance, these lightweight, fiber-reinforced nylon rod ends also reduce noise and vibration.

Make quick adjustments to these rod ends by inserting and releasing the clevis pins without the need to bend them into place.

Attach these nuts to rods, pipes, and tubes to make pivoting and hinge movements where misalignment is not a concern.

With strength for higher load capacities than other ball-grip positioning arms, these arms have a heavy duty construction.

Heavy duty construction adds strength for higher load capacities than other positioning arms.

Position small panels and displays with these compact arms.

A suction base makes it easy to move and attach these arms to smooth surfaces such as glass and polished metal.

Bend these arms to hold small equipment such as lights and microphones in almost any position.

Nickel-plated steel has some corrosion resistance.

Yellow zinc-plated steel is more corrosion resistant than nickel-plated steel.

An economical choice for applications in corrosive environments that don't require high load capacities, these mounts have a plastic base.

Made of 303/304 stainless steel, these mounts resist corrosion from water and most chemicals.

Made entirely of 316 stainless steel, these mounts have superior corrosion resistance.

Well-suited to damp environments, these mounts have a stainless steel stud and nut for corrosion resistance.

Punch-out holes in the base let you bolt down these mounts to keep your equipment stationary.

Well-suited to damp environments, these mounts have a stainless steel stud and nut for corrosion resistance.

Black-oxide steel has a dull shine for areas where appearance is a concern.

An economical choice for applications in corrosive environments that don't require high load capacities, these mounts have a plastic base.

Made of 303 stainless steel, these metric mounts resist corrosion from water and most chemicals.

Well-suited to damp environments, these mounts have a stainless steel nut for excellent corrosion resistance.

All-stainless steel construction stands up to water and chemicals and won't rust or corrode.

Thread these mounts into machinery to level them on uneven floors in sanitary environments such as food-processing areas.

A two-piece design requires less clearance than one-piece mounts and simplifies installation—raise your machine just enough to slide the base underneath, then insert the stud from above.

Higher deflection ratings translate to greater vibration and shock isolation.

Cover the bottom of furniture legs.

Attach these fittings to the end of a ball screw jack to create pivoting connections with clevis rod ends and other linkages.

Low-friction ball bearings allow these screw jacks to use half the power required by an Acme screw jack to lift the same load. Typically used as actuators, they run at higher speeds than Acme screw jacks.

The mounting plate provides a flat surface for supporting loads.

Attach to the end of a screw or threaded stud to apply uniform pressure on uneven and angled surfaces. Also known as toggle and swivel-foot pads.

The contact area is covered in plastic to protect soft metal and polished surfaces. Attach these tips to the end of a screw or threaded stud to apply uniform pressure on uneven and angled surfaces. Also known as toggle and swivel-foot pads.

A spring-loaded socket locks your gas spring to the ball stud—squeeze the ends together to attach and to release.

Thread these ball socket end fittings onto gas springs. They rotate in any direction on a ball stud to compensate for misalignment.

These end fittings snap right on a ball stud—an integral retaining clip grips the ball stud for secure attachment until you apply enough force to pop it off.

For exact positioning, these hoses swivel 360°.