More sustainable than standard UHMW, these sheets and bars are made from partially recycled material, so they have a lower carbon footprint.

Made with carbon black, these recycled UHMW sheets are a sustainable alternative to standard UHMW sheets in applications where static electricity is a concern, such as in conveying equipment and chute liners.

Compared to our standard UHMW polyethylene, these sheets and bars hold up better to scuffs and scrapes in high-speed, high-precision, and high-impact applications—such as conveyor equipment, chute liners, and machine guards. Also known as Tivar HPV.

Also known as Tivar H.O.T., this material lasts up to 10 times longer in high-temperature applications than standard UHMW.

If a chip of this material breaks off, it can be located by metal detectors to reduce contamination risks.

Designed for extreme wear resistance, this Kevlar-filled nylon 6/6 material lasts up to 20 times longer than unfilled nylon. Also known as Hydlar Z, it is often used for parts that are continuously exposed to wear and abrasion, such as wear strips and bushings.

Because this 6/12 material absorbs less water than standard nylon 6/6, it holds its shape better. It’s often machined into hose fittings and valve components.

This nylon stays lubricated over time because it’s filled with oil. Use it to fabricate parts for hard-to-reach places where adding lubricants would be difficult.

This cast nylon 6 material is easier to machine than other types of nylon. It’s comparable to Nylatron and Nycast.

The addition of PTFE provides a more slippery, wear-resistant surface than standard Delrin® acetal resin. It’s commonly fabricated into pump components, gears, and bearings.

An economical alternative to Delrin® acetal resin, this acetal copolymer offers similar wear resistance.

Widely used in semiconductor applications, this polypropylene meets UL flame-retardance standards.

Known for its naturally slippery surface, PTFE surpasses most plastics when it comes to chemical resistance and performance in extreme temperatures.

This film is made with virgin Teflon® PTFE resins. It can handle extreme temperatures and resists most solvents.

Filled with carbon and graphite, this naturally slippery PTFE stands up to wear better than standard PTFE.

A layer of tin-plated steel adds structural support and makes this PTFE easy to form.

Not only does PEEK provide superior wear resistance in repetitive processes, it is also resists wear caused by abrasion. PEEK can be used as a lightweight substitute for metal parts in chemical-processing applications.

These PEEK sheets can be machined to tight tolerances for use in electrical and semiconductor parts, such as test sockets.

Stronger than PTFE, PVDF offers good chemical resistance. Comparable to Kynar and Solef, it’s widely used for pump parts, tank liners, and seals.

Suitable for food contact, these plates are made of FDA listed UHMW plastic, which has a slippery surface to minimize friction. Often found on conveyor systems, use these plates where friction between two parts or materials is wearing down equipment to extend equipment life.

With a thin metal backing, these sheets are good for use in bumpers, wear pads, machinery mounts, and other applications where some structural support is needed.

Increase the life of rope slings by positioning these protectors over areas prone to wear.

A good all-around choice, Garolite G-10/FR4 is strong, machinable, and electrically insulating. It meets UL 94 V-0 for flame retardance.