An adjustable thermostat senses the container’s surface temperature to automatically control heat output.

Nonstandard-size containers are no problem—use the hook-and-loop closure to adjust these heaters to fit a range of diameters.

Also known as heat blankets, these heaters completely surround containers for fast heating and increased heat retention in unheated and drafty areas.

Attach to flat metal surfaces.

Often used for temporary heating in sinks and pails, these heaters have a circular base that sits at the bottom of containers. Remove them from the container after heating its contents.

Often used for freeze protection in outdoor containers, these heaters float on the water’s surface and automatically keep the temperature between 45° and 65° F.

Hook these heaters on the side of small drums and pails.

Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

Wrap the flexible fiber heating element around small-diameter pipes and tubes or pack it into tight spaces.

For demanding applications such as hot-melt transfer pipes, these heaters have a maximum heat output of 1400° F.

An adjustable thermostat automatically turns the heater on when the temperature drops below your set temperature and off when it rises above your set temperature.

Install near loading docks and other drafty areas to warm people and objects.

Stay warm at a desk, counter, or table.

Blast your heating, drying, and shrinking projects with hot air to get the job done quickly. Choose from blowers with temperature settings from 300° to 750° F.

Shaped like a large flashlight, use these wands to loosen stuck nuts, heat bearings, and repair dents.

Spot-dry paint, adhesives, and other surface coatings and fillers.

Position these lamps at any angle to heat, dry, soften, or defrost.

Mark the bearing with the included temperature-indicating crayon; the bearing has reached 250° F when the crayon mark melts.

Flip the switch to heat bearings to 250°.

Heat metal containers on the coiled burners.

Heat PVC conduit and pipe, then manually bend it to your desired angle.

Keep feet warm in cold, drafty rooms.