Screw these clamps directly into a tapped hole and use air pressure to quickly and consistently clamp and release parts. The arm rotates 90° into position over the workpiece and then moves straight down to clamp. Disengage to rotate the arm out of the way and load or unload parts. Also known as swing clamps, they're used with a solid state switch or Reed function switch with M8 male 3-pin connectors. Connect the clamp's ports to a control valve and an air line. To hold clamps in an untapped hole, use a mounting block (sold separately).

Clamps with rubber-tipped holding screw are nonmarring. Tip is removable.

For technical drawings and 3-D models, click on a part number.

Adjust the air pressure to quickly and consistently clamp and release parts. The arm on these clamps rotates 90° into position over the workpiece and then moves straight down to clamp. Disengage to rotate the arm out of the way and load or unload parts. Also known as swing clamps, they mount with screws and are used with a solid state switch or Reed function switch with M8 male 3-pin connectors. Connect the clamp's ports to a control valve and an air line.

Clamps with rubber-tipped holding screw are nonmarring. Tip is removable.

For technical drawings and 3-D models, click on a part number.

Use for repetitive clamping and in production environments. These clamps secure when the plunger is fully extended to hold a workpiece from the side. Air from one inlet port engages the clamp, and air from the other inlet port disengages it. Clamps maintain the full-rated holding capacity even with a loss of air pressure. They have a threaded plunger to accommodate threaded holding screws and other threaded fixtures (not included). Fittings (not included) are required to connect the clamp's ports to a control valve and an air line.

For technical drawings and 3-D models, click on a part number.

Also known as vacuum chucks, these plates secure thin and flexible parts that can’t be held with vises or clamps for milling, drilling, routing, and finishing operations. Connect the system to your shop’s compressed air supply and it's ready to use. For applications requiring only part of the plate surface, use the gasket cord to seal off the area.

Risers, also known as vacuum pods, raise the workpiece off the vacuum table to give the cutting tool better access. Suction transfers from the table through the top of the riser, so to get a firm hold the workpiece must make contact with the full top length and width of the riser.

Retracting stop pins let you repeatably locate parts on your vacuum table. After positioning your workpiece against these pins, turn on the vacuum and the stop pins retract, dropping out of the way so the cutting tool has full access to the workpiece.

Side stops fit into the grooves of the vacuum plate to help you repeatably position material. They can be removed from the plate after the vacuum is turned on to give the cutting tool more access to the workpiece.

Combine these grippers with your gripping fingers to lift and move items in pick-and-place applications.

Grippers with a spring jaw return have a single air port to close the jaws and grip items from the outside. An internal spring opens the jaws to release the grip.

Grippers with a forced-air jaw return have two air ports: one to move the jaws open and another to move them closed. The jaws grip items from the outside as well as the inside.

Angular grippers allow a more secure grip on irregularly shaped loads.

Note: Choose a gripper with a holding force at least 10 times your item's weight.

Warning: Never use to lift people or items over people.

For technical drawings and 3-D models, click on a part number.

These grippers pick up a product and turn it 90° or 180° before releasing. Use them with gripping fingers to lift and move items in pick-and-place applications. They have two air ports: one to move the jaws open and another to move them closed. The jaws can grip items from the outside as well as the inside.

Warning: Never use to lift people or items over people.

For technical drawings and 3-D models, click on a part number.