Apply a layer of compound by holding one of these bars against a revolving buffing wheel.

A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface. These sheets resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

The dental floss of abrasives, these cords slip into areas that other forms cannot. They're good for deburring and polishing small holes, narrow slots, keyways, and grooves.

The mesh in these sanding pads flexes to compensate for uneven pressure as you sand, producing a consistent finish.

Providing the control of a sanding block while remaining flexible, these sponges sand around curves and in corners.

Cut to convenient sizes and shapes, these fit most sheet sanders.

The mesh backing lets sanding dust and debris escape during use, preventing material build up on the abrasive surface.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Holes allow dust removal when used with a vacuum sander.

A special fastener on the back of these discs allows you to easily swap one disc for another.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Fit these discs over your tool's arbor to sand aluminum, soft metals, and nonmetals.

With more flaps than standard discs, these last 30-40% longer.

One of the sharpest abrasives, the silicon carbide on these belts sands soft metals and nonmetals like aluminum and rubber with ease, and it generates minimal heat to prevent material buildup.

Leave a smooth, consistent finish on wide workpieces.