We will reply to your message within an hour.
More
Use this general purpose tubing to insulate and protect wire and cable.
The smallest heat-shrink tubing we offer, this tubing protects wire with a 0.017" and smaller diameter.
This tubing creates a tight seal over irregularly shaped objects.
Extra-thick walls provide more protection against abrasion and tears than standard high-shrink-ratio tubing. This tubing shrinks down to 1/6th of its original ID, so it creates a tight seal over irregularly shaped objects.
Identify ground wire with this green-and-yellow striped tubing.
Create a water-resistant seal—this tubing has an adhesive lining that melts when the tubing is heated and bonds to the underlying surface.
Extra-thick walls provide better protection against abrasion and tears than standard moisture-seal tubing, as well as creating a water-resistant seal.
Approved for contact with food, this tubing is FDA Compliant 21 CFR 177.1330.
Made of woven polyolefin/polyester fabric, this tubing has excellent abrasion resistance so it can be dragged over rough surfaces without damage.
Protect bus bars and other high-voltage devices—this tubing withstands voltages up to 5,000 volts.
After being cleaned with alcohol, this tubing is bagged and sealed in a clean room. It's certified for material quality and purity.
Also known as halogen-free tubing, this tubing produces minimal amounts of smoke and gas if exposed to an open flame, so it can be used in enclosed areas such as ships and tunnels.
A layer of conductive cloth protects wire and cable from signal interference caused by nearby equipment and devices.
Keep general purpose tubing in a variety of sizes on hand.
Maintain a supply of tubing in a variety of sizes that withstand abrasion, moisture, and chemicals.
Organize and route wire and cable in an enclosure—this tubing bundles wires together while allowing them to reach different connection points.
A different shrink ratio on each end allows this tubing to fit over cable assemblies and wire harnesses with large connections, or around connectors with a 90° elbow.
Seal the end of crimped connections, such as motor coils, to protect them from moisture.
Protect wire and cable without disconnecting them from an assembly. For a water-resistant seal, this wrap has an adhesive lining that melts when the tubing is heated and bonds to the underlying surface.
Use this wrap with heat-shrink tubing to create a moisture-resistant seal. Apply it like tape around wire and cable, then slide the tubing over the wrap. The wrap melts when tubing is heated and bonds to the underlying surface.
Protect thermocouple wire exposed to air in forging, die casting, heat treating, and other extreme-temperature applications.