These standoffs are made to NAS specifications.

Choose these standoffs for their adherence to NAS 1831 specifications.

Mount components onto food processing lines, walls, and sanitary equipment while leaving space to clean in between.

Protect components from electrical charges.

These standoffs are designed to fit in the limited space of compact electronics such as laptops and hand-held devices.

With the end clinched in place, the prongs allow you to quickly snap a panel on and off these supports.

Stick these supports to surfaces where you don't want to drill a hole. The snap-in end can be released for repairs and upgrades.

Both ends snap and lock in place for a permanent connection.

Designed for multi-level printed circuit board applications, these self-aligning, through-hole supports have a chamfered female end for stacking. The other end snaps and locks in place for a permanent connection.

The flat top supports boards without drilling a hole while wings on the other end add tension for a secure hold in a hole.

These include a barrel and a screw.

Use these barrels with a screw you already have or pair with a different type of screw to create a custom fastener. Made from 316 stainless steel, they have excellent chemical resistance and can be used in saltwater environments.

Pair with a barrel you already have or couple with a different barrel to create a custom fastener. Made from 316 stainless steel, they have excellent chemical resistance and can be used in saltwater environments.

Designed with a shoulder for the strength to handle side and shear loads.

These include a barrel and a screw.

An unthreaded barrel allows quick assembly with a press or a hammer.

One-third the weight of steel, aluminum binding barrels and screws resist corrosion in wet environments.

Stainless steel binding barrels and screws have excellent corrosion resistance in most environments.

Plastic binding barrels and caps are chemical resistant, nonconductive, and lightweight.

Create strong joints in wood and wood composite.

Brass binding barrels and screws are corrosion resistant in wet environments and electrically conductive.

Install these binding barrels and screws with a standard slotted screwdriver. They require a special tool to remove.

A tamper-resistant Torx driver is required for installation and removal.

This solid plastic bollard resists oil and chemicals and won’t rot from outdoor exposure.

Restrict and grant access to an area—these bollards act as a strong physical barrier and have a hinge to fold flat against the ground in either direction.

These are the same guardrails you see along roadways.

During light collisions, these guardrails tilt to absorb impact and minimize damage to a vehicle.

These guardrails sit low to the ground to protect racks and equipment without restricting access.

Provide an end point for a belt barrier.

Use these posts to securely mount mailboxes into the ground or concrete.

Cut through soil to create a smooth, round hole.

These posts include a base that's portable, but hard to knock over.

A plastic guard reduces damage from impact and protects vehicles.

These holders come with a cover to protect signs from smudging and wear.

Use these cones for quick material identification, inventory control, and pallet staging.

These flexible reflectors return to the upright position after contact. They are visible from both sides for areas where traffic moves in two directions.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Create posts of varying lengths.

Use four brackets to support the top and bottom edges of panels without drilling holes in them.

Stack multiple ring or spade terminals on the stud terminal; the current flows through the stacked terminals.

Raise your enclosure to access switches, gauges, screens, and other parts at a comfortable working height.

Convert one battery terminal style to another.

Grip square-shank lathe tools.

Four flat head screws lock down round-shank tools in a precision-ground bore for increased rigidity over other round-shank tool holders.

These holders work with any 5C collet to rigidly grip drill bits, taps, end mills, and other tools.

Mount any tool with a Morse taper shank to a quick-change tool post.

Place a cutoff blade into one of these holders to keep it in place in the lathe.