We will reply to your message within an hour.
Often used for high-precision and sensitive electronics such as testing and audio equipment, these power supplies produce low output noise for minimal electronic interference.
Prevent accidental contact with live electrical connections—the screw terminals are covered or recessed. These transformers can handle momentary high-inrush current associated with contactors, solenoids, and relays.
Sealed coils protect against dust, dirt, oil, and moisture. These transformers can handle momentary high-inrush current associated with contactors, solenoids, and relays.
These transformers can handle momentary high-inrush current associated with contactors, solenoids, and relays.
These transformers have isolated primary and secondary coils to protect your sensitive equipment from input voltage spikes.
Protect equipment from electromagnetic interference and maintain power during three-millisecond power dips.
Use the included mounting plate to mount these transformers to a panel. They can handle momentary high-inrush current associated with equipment start-up.
Power low-voltage devices such as alarms and sensors.
Hardwire this transformer into your panel.
Permanently install these transformers in panels.
Mount these portable transformers to any flat surface.
Flip the switch to reverse the magnetic current and release your electromagnet's hold.
Suitable for high-speed automated applications, these transformers reverse the magnetic current and release your electromagnet's hold faster than other electromagnet transformers.
Transfer power to a built-in battery during brownouts and blackouts with only a momentary loss of power during transfer.
Smaller in height than standard backup power supplies, these fit in tight spaces.
Prevent damage to sensitive equipment—these conditioners raise or lower current to keep it at a normal level during dips and surges.
Change AC voltage to DC voltage to power extremely sensitive audio, measuring, and testing devices while keeping electronic interference—often called output or ripple noise—from passing on to the device.
Convert AC voltage into the DC voltages needed to test, design, and prototype a wide variety of electrical circuits and equipment.
Use your computer to remotely control these power supplies that convert AC voltage to DC voltage for powering electronics from simple prototypes to advanced testing equipment.
No need to adjust the voltage on these power supplies—they’re specifically designed to convert 120V AC to 13.8V DC.
Mount these power supplies into standard 19”-wide electronics racks, which can hold multiple electronic devices and keep your benchtop clear.
Send electricity to LED lights while protecting them from voltage and current fluctuations.
These chargers are for use with most DeWalt batteries, except Univolt batteries.
Energize Milwaukee tool batteries with these chargers.
Recharge batteries for Makita tools.
Use these chargers with Black & Decker batteries.
Restore power to batteries for Dremel tools.
Keep Bosch tool batteries powered with these chargers.
Charge multiple devices at once.
Charge up to eight batteries at once.
Bring batteries to these chargers for maintenance.
Charge batteries even in wet environments—a sealed housing keeps water out.
After the battery is fully charged, these chargers continuously provide a low-level charge to maintain the battery without overcharging.