To run DC-powered lab and medical equipment from your outlet, add a power cord with the plug style and length you need. These adapters meet strict IEC, UL, or ANSI/AAMI standards for use with medical devices. They also have a Means of Protection rating of 2xMOPP, which is the highest level of shock protection available for medical-grade power supplies, so in addition to using them with lab and medical equipment, you can use them with devices that come into contact with patients.

Unlike adapters with bodies that plug directly into an outlet, the body of these adapters rests on a desk or the floor, so it won’t block multiple outlets. Adapters with an IEC C8 input connection require power cords with a C7 socket. Those with an IEC C14 input connection require power cords with a C13 socket.

When selecting an adapter, make sure the DC voltage and amps for the pin output connection can handle the requirements of your device. Choosing a DC voltage and amps that are much higher than you need will not improve performance.

These adapters use switching regulation, which means they produce the stated voltage despite fluctuations in your outlet’s power and the power being drawn by your device. It also means they won’t get too hot.

If you exceed the maximum voltage or load, these adapters shut down to protect both the adapters and the connected equipment.

All of these adapters meet European safety standards. Adapters with Class II shock protection have two levels of insulation to prevent electrical shocks. Those with Class I shock protection prevent electrical shocks with a combination of insulation and a protective ground.

Swap the plug to match the outlet of the region you’re in instead of using separate cords for each country. These adapter cords convert AC voltage to power DC electronics. Designed with switching regulation, they maintain consistent voltage during power fluctuations and don’t get too hot. They meet U.S., Canadian, European, Australian, New Zealand, and Chinese safety standards.

A limited power source (LPS) low-voltage output decreases the risk of electric shock if something fails inside these cords. Class II shock protection means they have two levels of insulation. These cords meet U.S. DOE (Department of Energy) Level VI standards for energy efficiency when they're in-use, as well as when they're plugged in but not in use.

Choose an adapter cord with an output voltage that matches the voltage of your device. The polarity of the adapter cord and your device must also be the same. Look for the polarity illustration on your device or the adapter cord you’re replacing and pick a cord to match.

Install these connectors directly onto circuit boards to carry DC power from a power supply to your device. The industry standard barrel-style ends are often found on power supplies for laptops, wireless routers, and other common electronics. Push the contacts through holes in your circuit board and solder them in place.

Push-in connectors are quicker to connect and disconnect than screw-together connectors.

Screw-together connectors are less likely to disconnect from vibration or getting yanked out than push-in connectors. This makes them good for preventing power loss. However, they take longer to connect and disconnect.