We will reply to your message within an hour.
Small and lightweight, these enclosures are used with sensors, switches, and testing devices.
Keep electronics safe from harmful contact with hands and tools while still allowing air and moisture to enter.
These enclosures allow you to inspect your electronics without opening the cover.
Two separate chambers allow you to access wiring connections in the lower section without disturbing components that you install in the upper section.
Attach these vents to the top or side of sealed enclosures, so air can flow through to equalize internal and external temperature and pressure.
Protect tablet computers, touch displays, and readouts in these specially sized enclosures. They are rated IP65 for protection from spraying water.
Create battery-powered, hand-held devices such as card and signal readers—these enclosures have a clear cover for checking screens and status lights inside.
A 9-volt battery fits inside a compartment in these enclosures to power testing devices and other hand-held instruments.
Protect monitors and televisions from environmental damage with these enclosures.
Use these open boxes with adhesive for electronics (also known as potting compound) to encase electronic assemblies and protect them from vibration, tampering, moisture, and corrosives.
For use in enclosures and panels where components require battery power, these enclosures have contacts for AA and 9-volt batteries.
Save time when wiring connections in a junction box; these blocks come already installed in an enclosure.
Inspect the terminal block and wiring without opening the cover.
Holders have snap-on or screw-on covers to fully enclose and protect batteries.
Seal T-slots, rail ends, and gaps between rails to keep out dust, debris, and other contaminants.
Made of ABS plastic, these plastic guards won’t rust, and they absorb impact from chain and belt drives.