Control a single heating or cooling device in your enclosure to keep electronics at a safe operating temperature.

Since these switches don’t have a housing above the probe, they are often used in tight spaces and low-clearance areas.

To control heating equipment in washdown environments with splashing water, corrosive liquid, and dust, these switches have a housing that meets NEMA 4X.

These temperature switches mount on walls and take remote temperature readings with a probe on a cable.

Housing is UL listed for environments with flammable gases, combustible dust, and ignitable fibers, such as chemical plants, refineries, and grain elevators.

An adjustable reset lets you control the amount of temperature change, also known as deadband and differential, before these switches reset. When they reach the set temperature, they send an electronic signal to your programmable logic controller (PLC) to turn equipment on or off.

For high accuracy in applications with fluctuating conditions, these controllers have proportional-integral-derivative (PID) software with fuzzy logic that learns system behavior and automatically compensates for changes.

For protection in washdown conditions with splashing water, corrosive liquid, and dust, these controllers have a wall-mount housing that meets NEMA 4X. They’re ideal for systems with rapid, unpredictable, or complex temperature changes.

Install these controllers in DIN panel cutouts to maintain your heating equipment’s temperature. When your machine gets too hot, they turn it on and off in short cycles to cool it down.

The simplest temperature controllers—they turn devices fully on or off, with no middle state, at a given temperature.