To avoid gouging and marring your pipe while making adjustments, these collars have flats where you can grab and rotate the pipe with a wrench. They're sized precisely for a tight fit around pipe, so they're often used to support pipe passing through floors and walls. They can also easily be machined to hang signs. Since they’re two pieces, you don’t need to have access to the ends of your pipe to install them. Tighten the clamping screws to secure. They’re black-oxide steel, so they have some corrosion resistance.

To install, unscrew the fitting, slide over the wire rope, then tighten the pieces together with a wrench. Use for light-duty securing, tethering, and suspending. Made of 316 stainless steel, these are the most corrosion resistant fittings we offer.

Warning: Fittings must match rope diameter and be installed correctly to obtain maximum holding power. Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.

Sized to fit snugly around pipe, these collars have flats so you can turn the collar and your pipe using a standard wrench. This means you don't need to use a pipe wrench, which could scratch the surface of your pipe. These collars are also often used as a stop to support pipe as it passes through floors and walls. They’re also easy to machine, so you can drill and tap a hole through one of the flats to hang a sign. Swing them open to fit over your pipe and tighten them with a single screw—they’re faster to install than two-piece collars. All have captive screws, which won’t fall out of these collars even when fully unthreaded. Made of black-oxide steel, they have some corrosion resistance.

Compress the thin shank wall with a hand tool (sold separately) to attach these light duty end fittings. They are also known as hand swage fittings. Made of 316 stainless steel, these are the most corrosion resistant fittings we offer.

Warning: Fittings must match rope diameter and be installed correctly to obtain maximum holding power. Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.

Install and route multiple lines of pipe, tubing, or conduit with a single hanger that locks in place quickly. Pinch the mounting brackets together, slide onto a threaded rod, and release. Open the latch to add, adjust, and remove lines as needed. You can also detach the hanger from the mounting brackets to secure lines directly to flat surfaces.

Also known as socket-end swage fittings, install these end fittings with a roller swage press for a strong, per manent hold. They have a thicker shank wall than compression-grip end fittings. Made of 18-8 stainless steel, they offer excellent corrosion resistance to chemicals.

Warning: Fittings must match rope diameter and be installed correctly to obtain maximum holding power. Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.

Fray the end of the wire rope with a marlin spike and screw the socket over the plug to install. An inspection hole confirms proper installation—If wire strands are visible, the fitting has been properly secured.

Use an assembly kit (not included) to support the wire rope while you drive the plug into the wire rope end.

Warning: Fittings must match rope diameter and be installed correctly to obtain maximum holding power. Test all assemblies for required strength before use. Never exceed load capacity. Do not use with coated rope unless the coating is removed.