Keep gas flowing even when the temperature drops—also known as heat blankets, these heaters wrap around propane tanks to safely warm liquefied gas so it can vaporize. These heaters are sized to fit industry-standard propane tanks. Quickly install and remove them using the buckles or latches. A GFCI is built into the power cord to prevent electrical shocks.

Extend the shelf life of your diesel exhaust fluid (DEF) while storing it in cold places. Also called heat blankets, these heaters wrap around 330 gal. DEF totes to evenly warm the fluid inside. They’re insulated with foam, so they retain heat even in chilly environments. Designed for DEF totes with a built-in pump, these heaters have an extended frame to fit the pump housing and an opening for the pump equipment. Manually set the temperature with the digital keypad. A thermostat automatically turns these heaters on and off to maintain the set temperature. To prevent overheating, a resettable fuse opens if the temperature rises above the maximum heat output.

Secure these heaters with the included buckles and straps—no need for adhesive. They’re quick to unbuckle and remove once your tote is empty.

A ground fault circuit interrupter (GFCI) is built in to their power cord to prevent electrical shocks.

Strap these heaters around cylinders to keep gas flowing when the temperature drops. Also known as heat blankets, they heat cylinders from the outside, safely warming liquefied gas enough so that it can vaporize. They’re sized to fit industry-standard cylinders. Do not use these heaters in hazardous areas.

These ETL-listed heaters keep containers warm in areas where hazardous material is present. Also known as heat blankets, they surround drums and totes to heat them up quickly. They’re also insulated with foam or fiberglass to retain heat. They have a built-in thermostat that cycles on and off to keep contents at a set temperature. There's no need to monitor these heaters—since the temperature can’t be changed, there’s no risk of tampering.

Cool the contents of your pail, drum, or tote from the outside. Since they cool from the outside, there's no risk of introducing contaminants to your material. These coolers are often used to stabilize solutions or keep liquids from evaporating. Connect them to a chiller or water source to circulate cold liquid around your container. Secure them with elastic straps. When they’re filled, these coolers conform to the surface of a container, eliminating air pockets to cool evenly. A layer of insulation locks in the cold and reduces condensation. As liquid flows out of these coolers, you can channel it back into your chiller or empty it into a drain.

You can also use these coolers to keep material warm—they circulate fluid up to 120° F. When using them at temperatures above 45° F, fill with water only.

Keep liquid in your pipes from freezing, maintain a specific viscosity, and prevent condensation in cold areas. Also known as heat blankets, these heaters wrap around your pipe to quickly warm the contents without direct contact. Do not use in hazardous areas.