About Linear Bearings
More
Press-Fit Reamer Bushings


With ID tolerances sized specifically for reamers, these bushings ensure steady and precise hole finishing. Press them into a fixture plate with a manual or hydraulic press for permanent installation. Also known as headless bushings, these ANSI-type P bushings don’t need counterboring to be mounted flush. They are made of hardened, ground steel that holds its shape and resists wear, so they last for many cycles without needing to be replaced.
Tolerance | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
ID | OD | Lg. | For Reamer Size | ID | OD | Lg. | Drill Bushing Type | Material | Hardness | Each | |
0.39" | 5/8" | 3/4" | 0.39" | 0.0006" to 0.001" | 0.0014" to 0.0017" | -0.01" to 0.01" | P | Steel | Rockwell C61 | 00000000 | 00000 |
Sleeve Bearing Blocks for Washdown Environments


Made from a single piece of slippery UHMW plastic, these bearings have no cracks or crevices so they’re easy to clean. All are for use with round end-supported shafts and have a fixed-alignment design for applications where shaft misalignment is unlikely.
Overall | Max | Mounting Holes | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | Wd. | Ht. | Center Ht. | Dynamic Load Capacity | Static Load Capacity, lbs. | PV | P, psi | V, sfpm | Temperature Range, ° F | No. of | Thread Size | Each | |
Fixed Alignment | |||||||||||||
1" Overall Lg. UHMW Bearings | |||||||||||||
3/8" | 3 1/4" | 1 1/4" | 9/16" | 5 lbs. @ 100 fpm | 80 | 2,000 | 1,000 | 100 | -200° to 180° | 2 | 5/16"-18 | 0000000 | 000000 |
2" Overall Lg. UHMW Bearings | |||||||||||||
3/8" | 3 1/4" | 1 1/4" | 9/16" | 15 lbs. @ 100 fpm | 160 | 2,000 | 1,000 | 100 | -200° to 180° | 4 | 5/16"-18 | 000000 | 00000 |