Filter by
System of Measurement
ID
Mounted Bearing Type
Bearing Seal Type
Shaft Mount Type
Alignment Style
Housing Material
Unit Price
Number of Set Screws Included
Grease Fitting Included
Shaft Type
Bearing Type
Mounting Hole Diameter
For Load Direction
Mounting Hole Width
Lubrication
Mounting Hole Center-to-Center
DFARS Specialty Metals
ABEC Rating
Dynamic Radial Load Capacity
About Ball and Roller Bearings
More
Easy-Align Mounted Ball Bearings with Two-Bolt Flange
An elongated mounting hole on one side of the flange lets you adjust the position of these bearings without having to remove your shaft. You only need to loosen the bolt instead of removing it to adjust. They’re self-aligning to compensate for shaft misalignment.
Overall | Mounting | Radial Load Cap., lbs. | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | Ht. | Lg. | Wd. | Flange Thick. | Hole Dia. | Hole Lg. | Hole Ctr.-to-Ctr. | Dynamic | Static | Max. Speed, rpm | Temp. Range, ° F | Alignment Style | Lubrication | Each | |
Sealed Steel Bearings with Cast Iron Housing | |||||||||||||||
Shaft Mount Type: Set Screw | |||||||||||||||
| 5/8" | 2 5/16" | 3 27/32" | 1 1/4" | 7/16" | 25/64" | 1 9/16" | 3 5/64" | 2,850 | 1,450 | 5,500 | 0° to 210° | Self Aligning | Lubricated | 0000000 | 000000 |
Easy-to-Weld 4130 Alloy Steel Round Tubes
- Yield Strength: See table
- Hardness: See table
- Heat Treatable: Yes
- Max. Hardness After Heat Treatment: See table
- Fabrication: Seamless
- Specifications Met: See table
Also known as chrome-moly steel, these 4130 alloy steel round tubes have low carbon content for good weldability. They’re often used for roll cages and frames. To increase their wear resistance, you can harden them with heat treating. These tubes have been manufactured to SAE and military standards for quality and performance.
Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.
| OD | ID | Yield Strength  | Hardness | Maximum Hardness After Heat Treatment | Specifications Met | Straightness Tolerance | 1 ft. Lg. | 3 ft. Lg. | 4 ft. Lg. | 6 ft. Lg. | 8 ft. Lg. | 12 ft. Lg. | |
0.065" Wall Thick. | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 3/4" | 0.62" | 70,000 psi | Rockwell C19 | Rockwell C49 | MIL-T-6736, SAE AMS-T-6736, SAE AMS6360 | 0.030" per 3 ft. | 000000000 | ||||||