19.9997mm ID Bearings | McMaster-Carr

Smoother than smooth—the balls inside these bearings roll nearly friction-free. You’ll often find them on rapidly rotating parts, from the whirring chuck on a power drill to the spinning shaft on an electric motor.

Open—With no rubber seal to block airflow, these bearings dissipate heat quickly, extending the life of the lubricant and reducing friction over time.

Shielded—The balls are covered just enough to keep out large particles while allowing air to pass through and dissipate heat.

Sealed—The best choice for dirty environments. A barrier seals out dust so it won't gunk up or wear down the balls. However, these bearings retain the most heat since air can't flow through.

Steel—Strong and wear resistant. However, these bearings are best for dry environments since moisture will cause them to rust.

ABEC Rating—Bearings with an ABEC rating meet industry tolerance standards established by the Annular Bearing Engineers Committee (ABEC). They're rated on a scale from 1 to 9. The higher the rating, the tighter the tolerance. Bearings rated ABEC 1 or 3 are precise enough for most applications. If your application consistently runs at high speeds or requires high accuracy, consider bearings rated ABEC 5 or higher, since they generate less friction and heat.

							Temp. Range, ° F
	For Shaft Dia., mm	For Housing ID, mm	Wd., mm	ABEC Rating	Dynamic Radial Load Cap., lb.	Max. Rotation Speed, rpm	Min.	Max.	Inner Ring Type	Bearing Trade No.		Each
Open







				Steel

				20	32	7	1	900	21,000	-20	230	Standard	6804	5972K215	000000


				20	37	9	1	1,400	19,000	-20	230	Standard	6904	5972K245	00000


				Shielded







								Steel

								20	32	7	1	900	21,000	-20	230	Standard	6804-2Z	5972K157	00000


								20	37	9	1	1,400	19,000	-20	230	Standard	6904-2Z	5972K168	00000


								Sealed







												Steel

												20	32	7	1	900	21,000	-20	230	Standard	6804-2RS	5972K279	0000


												20	37	9	1	1,400	19,000	-20	230	Standard	6904-2RS	5972K291	0000