Filter by
System of Measurement
OD
Bearing Seal Type
Bearing Type
Material
Roller Bearing Type
For Load Direction
Cage Material
For Rod End ID
Bearing Construction
DFARS Specialty Metals
Export Control Classification Number (ECCN)
RoHS
Maximum Rotation Speed
Performance
Maximum Temperature
Dynamic Radial Load Capacity
For Shaft Surface Smoothness, Ra
Minimum Temperature
Precision Needle-Roller Bearings
 |  |
Bearing |
Install these bearings directly onto hardened and ground shafts. They have higher load capacity, speed, and accuracy than standard needle-roller bearings.
Open Bearing—Open bearings dissipate heat more efficiently than sealed bearings.
Shaft Liners—Shaft liners allow you to use the bearing on unhardened and unground shafts.
Bearings | Shaft Liners | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Radial Load Cap., lb. | ||||||||||||||||
For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Dynamic | Static | Max. Rotation Speed, rpm | Lubrication | For Shaft Surface Smoothness, Ra, μin | Temp. Range, ° F | Features | Each | For Shaft Dia., mm | Each | ||||
For Radial Load—Open with Steel Ring | ||||||||||||||||
| 25 | 33 | 16 | 3,350 | 5,000 | 17,000 | Required | 4 | 0 to 245 | Lubrication Groove, Lubrication Hole | 2423K28 | 000000 | 20 | 2423K48 | 000000 | ||
Ball Joint Rod End Seals
 |  |
Shown Installed |
For Rod End ID, mm | ID, mm | OD, mm | Overall Ht., mm | Material | Washer Material | Pair | ||
|---|---|---|---|---|---|---|---|---|
| 18 | 18 | 33 | 8 | Buna-N | 304 Stainless Steel | 4737T18 | 000000 |
Flanged Screw-Clamp Bushings
 |  |
A mounting flange prevents movement during tightening. These bushings are good for shock loads. When you tighten the included screws, the bushing's inner sleeve contracts onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear. They can be mounted on shafts with or without keyways.
For Shaft Dia., mm | OD, mm | Overall Wd., mm | Max. Torque, in·lbf | Fastener Tightening Torque, in·lbf | Includes | Each | |||
|---|---|---|---|---|---|---|---|---|---|
Steel | |||||||||
| 19 | 33 | 24 | 1,050 | 42 | Clamping Screws | 1058K73 | 000000 | ||
Corrosion-Resistant Flanged Screw-Clamp Bushings
 |  |
Made from stainless steel or plated with nickel, these bushings resist corrosion. A mounting flange prevents movement during tightening. As screw-clamp bushings, they're good for shock loads. When you tighten the clamping screws, the bushing's inner sleeve tightens onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear.
Nickel-Plated Steel—Nickel-plated steel bushings have good corrosion resistance in wet environments. However, the plating may begin to flake with long-term use.
Stainless Steel—Stainless steel bushings have excellent corrosion resistance and can withstand prolonged exposure to moisture.
