McMaster-Carr logo
    Filter by
    System of Measurement
    OD
    Attribute Image
    Shaft Diameter
    Attribute Image
    Thickness
    Material
    Dynamic Thrust Load Capacity
    Bearing Type
    Bearing Seal Type
    For Load Direction
    Roller Bearing Type
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    U.S.–Mexico–Canada Agreement (USMCA) Qualifying
    Industrial Info Compare
    Washer Material
    For Shaft Surface Smoothness, Ra
    Maximum Temperature
    Minimum Temperature
    Roller Material
    Rotation Speed
    Shaft Type
    Cage Material
    Lubrication
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    3 Products

    Needle-Roller Thrust Bearings

    Image of Product. Bearings. Front orientation. Thrust Bearings. Needle-Roller Thrust Bearings.
    Image of Product. Front orientation. Thrust Roller Bearing Washers.

    Bearings

    Washers

    Small but mighty, our thinnest rolling thrust bearings slot into tight spaces and spin at whirring speeds. Their long, slender rollers support thrust loads and reduce friction in everything from machine tool spindles to gearboxes.
    A cage holds the rollers in place. You can install these bearings without washers between hardened, ground surfaces for the thinnest profile. If you’re working with unhardened, unground surfaces, you’ll need two washers for the rollers to run on. This three-piece design is easy to lubricate, but the oil will attract dust and grime since it’s exposed.
    Steel—Strong and wear resistant. However, these bearings are best for dry environments since moisture will cause them to rust.
    Thrust Bearings
    Thin Washers
    Thick Washers
    For Shaft
    Dia.
    OD
    Thk.
    Cage
    Material
    Dynamic Thrust
    Load Cap., lb.
    Max. Rotation
    Speed, rpm
    Temp. Range,
    ° F
    Each
    Thk.
    Each
    Thk.
    Each
    Steel
    3 1/4"4 1/8"1/8"Steel11,6004,0000 to 2405909K9550000001/32"5909K9750000001/8"5909K984000000
     

    Washers for Needle-Roller Thrust Bearings

    Image of Product. Front orientation. Thrust Roller Bearing Washers.
    These hardened steel washers protect softer shafts and housings from the rolling contact of needle rollers. Without them, needle rollers can indent and score unhardened surfaces, leading to premature wear and bearing failure. Positioned between the bearing and each mating surface, these washers distribute thrust loads evenly and extend service life. They adapt needle-roller thrust bearings for unhardened, unground surfaces.
    For Shaft
    Dia.
    OD
    Thk.
    Washer
    Material
    Each
    3 1/4"4 1/8"1/32"Steel5909K975000000
    3 1/4"4 1/8"1/8"Steel5909K98400000
    back to top