To provide more mounting flexibility than other sensor and switch mounting brackets, the head rotates 360°. Use this bracket to position proximity, photoelectric, and light beam sensors and switches. It comes with six adapters to ensure a secure hold on a range of sensor sizes.

No separate hinges are required, these supports act as a hinge and lid support all in one. Springs provide lifting assistance to raise and hold lids open—slightly lift the lid to get it started and the support will do the rest. Manually shut the lids and the supports will hold them in the closed position. All are rated for maximum lid weight—do not exceed the weight listed. They can be used individually but should be used in pairs for lids longer than 24". Mounting position is determined as you look into your cabinet or chest.

When you don't have enough clearance for side-mount or under-the-counter slides, mount these to the base of your drawer. The slides fully extend for convenient access to the back of drawers. All have ball bearing rollers for smooth, quiet operation.

Before drawers can slam shut, a damper and spring on these slides catch your drawer and gently guide it closed. This mechanism protects the drawer, its contents, and cabinets from damage caused by harsh slams. Ball bearing rollers help them glide smoothly and quietly in and out of cabinets. They’re ideal for use in quiet environments, such as offices and hospitals. Mount them to the sides of drawer openings. If you need to remove your drawer from its cabinet, these slides have a lever release that separates the slide parts.

Keep environments free of contaminants—with plastic bushings, there's no metal-to-metal contact that can release particles as these supports open and close. Manually control these free-moving lid supports through their full range of motion. Raise the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid. To secure the lid in a closed position, use a latch or lock (not included; see our clean room magnetic latches).

They are rated for maximum lid weight—do not exceed the weight listed. The supports can be used individually but should be used in pairs for lids longer than 24".

Providing constant resistance through the full range of motion, these supports hold lids open at any angle up to 70° or 90°. Simply raise or lower the lid and let go—friction keeps it in position. These supports can be used individually but should be used in pairs for lids longer than 24". Mounting position is determined as you look into your cabinet or chest.

All of these supports are rated for torque instead of maximum lid weight. Calculate your lid's torque and make sure it falls within the range listed—too much torque will cause your lid to slam; too little will prevent it from closing. Torque = Lid Height (inches) × 0.5 × Lid Weight (lbs.).