Designed to fit most limit switches, this bracket allows switch-position adjustments after it's fastened to equipment.

Clamp around sensors and switches for a secure hold. Use these brackets to position pressure, proximity, photoelectric, and light beam sensors and switches.

Hold doors, drawers, and hatches closed with the turn of a handle. These latches turn 360° in 90° increments.

No separate hinges are required, these supports act as a hinge and lid support all in one. Springs provide lifting assistance to raise and hold lids open—slightly lift the lid to get it started and the support will do the rest. Manually shut the lids and the supports will hold them in the closed position. All are rated for maximum lid weight—do not exceed the weight listed. They can be used individually but should be used in pairs for lids longer than 24". Mounting position is determined as you look into your cabinet or chest.

Hold heavy lids open with these supports. Raise the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid. To secure the lid in a closed position, use a latch or lock (not included). All of these supports are rated for maximum lid weight—do not exceed the weight listed. They can be used individually but should be used in pairs for lids longer than 24".

Ratchet supports hold lids still at multiple angles.

When you don't have enough clearance for side-mount or under-the-counter slides, mount these to the base of your drawer. The slides fully extend for convenient access to the back of drawers. All have ball bearing rollers for smooth, quiet operation.