Attach these clamps by running a wire rope through the jaws to create an attachment point anywhere along the wire rope. The eye is often used with a ratchet puller.

Tighten conduit locknuts and ream both the inside and outside of conduit with one tool. These pliers have combination jaws with multiple curved openings to work with ½” (13 mm) and ¾” (19 mm) EMT conduit locknuts and ½” rigid conduit locknuts and flat nuts. Their machined nose fits snugly into locknut wings. They can also pull wire and fish tape, thanks to their serrated jaws. They have plastic grips for comfort.

Use a blower or vacuum to insert this lightweight threading line into conduit or raceway and attach it to your pulling rope to guide the rope. Made of polypropylene, this line is mildew resistant, so it can be left in place for future use.

Note: Not for directly pulling wire or cable.

Thicker than standard fish tape, this fiberglass tape remains stiff along its entire length for long runs of conduit and raceway. It’s nonconductive, so it’s safer to use around energized equipment than metal fish tape. Attach your wire to the tape and fish it through. Round and flexible, this tape handles making multiple bends in different directions. It’s also known as conduit rodder.

Extra-long handles enable access to hard-to-reach areas. Also known as lineman’s and combination pliers, these tools pull, bend, and cut wire. They have plastic grips for comfort.

Avoid the potential for an arc flash or short circuit that can occur when using conventional insulated tools with metal components. Completely metal-free, these pliers are plastic with ceramic cutting blades. They also protect against accidental contact with live electrical circuits. Pliers are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. Also known as lineman’s and combination pliers, use them to pull, bend, and cut wire.

Made of aluminum bronze that is FM approved, these nonmagnetic pliers satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Also known as lineman’s and combination pliers, use them to pull, bend, and cut wire. They have plastic grips for comfort.

Warning: Do not use these tools in direct contact with acetylene.

When there isn't clearance to use standard-grip pliers, the angled head on these tools gives you access. Also known as lineman’s and combination pliers, use them to pull, bend, and cut wire. Pliers have combination jaws with a flat area for general gripping and a curved area for round material. The ultra grip is made of hard and soft materials for comfort and slip resistance.

Secure a lanyard to the ring on the handle to prevent dropping your pliers when working at height. Also known as lineman’s and combination pliers, use these tools to pull, bend, and cut wire. The jaws have a flat area for general gripping and a curved area for round material. Pliers have an ultra grip made of hard and soft materials for comfort and slip resistance.

Made of stainless steel or titanium, these pliers are good for environments where moisture and other contaminants are present. Also known as lineman’s and combination pliers, use them to pull, bend, and cut wire. The jaws have a flat area for general gripping and a curved area for round material.

Deep serrations provide the firm grip necessary for pulling rebar tie wire, and the hook-shaped handle end keeps your hand from slipping off. Also known as ironworkers’ pliers, these tools also bend and cut wire. They have plastic grips for comfort. The jaws are spring assisted to open automatically when you release the handles.

Insulated grips protect against accidental contact with live electrical circuits. These pliers are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. Also known as lineman’s and combination pliers, use them to pull, bend, and cut wire. The ultra grip is made of hard and soft materials for comfort and slip resistance.