We will reply to your message within an hour.
More
The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.
These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.
Drill holes up to 1 1/2" in diameter.
These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.
These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.
Also known as A-taper bits, these fit rotary hammers with a taper-shank chuck.
A more controlled chip removal reduces heat buildup. Use these bits on brittle material such as block and brick.
The 1/4" hex shank allows these bits to be used with standard impact drivers.
Use these diamond-coated hollow bits for wet drilling of masonry, concrete, and rebar with a drilling rig.
Adapt a bit for use on a drilling rig with a different thread size.
Use these bits with handheld power drills, drill presses, and hammer drills.
Insert these bits directly into power screwdrivers, impact drivers, and other tools that accept 1/4" hex shanks.
The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers set to rotary-only mode.
Use these bits with handheld power drills and hammer drills set to rotary-only mode.
A built-in stop ensures repeatable drilling depths for installing drop-in anchors.
The SDS-Max shank has three deep slots and two shallow slots for use with SDS-Max-drive rotary hammers.
Multiple cutting edges on the tip allow these bits to drill quickly through natural stone, granite, and other hard, abrasive material.
Unlike traditional wire-installing drill bits, you do not need to strip the end of the wire when using one of these bits. After drilling, insert the wire into the bit's hollow shaft and pull through the hole.
A more controlled chip removal reduces heat buildup. Use these bits on brittle materials such as block and brick.
Drill holes using simultaneous rotary and hammering action to break masonry material into tiny granules.
These chisels have a combination round and hex shank that works with spline-drive rotary hammers.
Also known as United States Navy (U.S.N.)-style chisels, these tools have an oval or round collar on the shank.
Also known as jumbo shank chisels.
These chisels work with electric and air-powered pavement-breaker hammers.
Use with air-powered pavement-breaker hammers.
Use with electric demolition hammers.
Made of aluminum-bronze that is Factory Mutual approved, these chisels inhibit sparking and are nonmagnetic and corrosion resistant. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.
Use with Air-Powered Needle Scalers/Chiseling Hammers.
Made of aluminum-bronze that is FM approved, these chisels satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.
Use with electric and air-powered pavement-breaker hammers.
The diamond-grit edge on these hole saws cuts more accurately, leaves a smoother finish, and lasts up to twice as long as carbide-grit-coated teeth.
These saws have carbide-grit-coated teeth.
The saws in these kits have carbide-grit-coated teeth that cut ceramic tile, fiberglass, masonry, plastic, and composites.