McMaster-Carr logo
    Filter by
    System of Measurement
    For Caliper Measurement Range
    Measuring Increments
    Environment
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    DFARS Specialty Metals
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    11 Products

    Center-to-Center Measuring Caliper Tips

    Image of ProductInUse. Shown Installed. Front orientation. Caliper Tips. Center-to-Center Measuring Caliper Tips.
    Image of Product. Front orientation. Caliper Tips. Center-to-Center Measuring Caliper Tips.

    Shown Installed

    Install these tips, also known as centerline gauges, onto the jaws of electronic, dial, and vernier calipers to measure the center-to-center distance between two holes. A 60° conical shape allows the tips to fit snugly into holes.
    For Caliper Measurement
    Range
    Slot
    Wd.
    Lg.
    Material
    No. of
    Tips
    Includes
    Each
    0" to 4", 0" to 6", 0" to 8"1/8"2 5/16"Stainless Steel
    2Hex Key Wrench00000000000000
    0" to 12"1/8"2 3/4"Stainless Steel
    2Hex Key Wrench0000000000000

    Calipers for Measuring Center-to-Center

    Image of Product. Front orientation. Calipers. Calipers for Measuring Center-to-Center.
    Find the exact distance between the centers of two holes without calculating their diameter. The tapered tips of the jaws stay centered in holes and bores for accurate measurements every time. Extend or shorten one jaw to measure parts with uneven surfaces, such as flanged bearings.
    With an LCD display, these calipers give instant measurements—no need to count graduations. Swap between inch and metric or set the position to zero, all with the press of a button. You don't need to reset the zero point since they retain their position when turned off, also known as absolute (ABS) positioning.
    Mitutoyo—The go-to for machinists and engineers. Every part of these calipers is made within Mitutoyo's automated system and tested in-house in Japan. Their jaws are laser cut to exact dimensions for the most reliable measurements.
    With SPC Data Output—Send measurements to a computer or data processor to store, analyze, and manage data. You'll need a data cable or SPC wireless transmitter and receiver.
    Calibration Certificate—Choose these calipers when precision measurements are required for quality control or by regulation. The certificate is traceable to NIST, so you can be confident your measurements are correct and consistent.
    Measuring
    Range
    Accuracy
    Measuring
    Increments
    Calipers with
    Calibration Certificate
    Inch
    Metric,
    mm
    Inch
    Metric
    Inch
    Metric,
    mm
    Overall
    Lg.
    Body Material
    Jaw Material
    Enclosure
    Rating
    Mfr. Model
    No.
    Each
    Mitutoyo
     
    With SPC Data Output
    0.4" to 6.4"10 to 160±0.0015"±0.04 mm0.0005"0.019"Stainless Steel
    Stainless Steel
    IP67
    573-705-2000000000000000
     
    Accessories and Replacements for Calipers
    back to top