The cleanest, safest way to blast. These blasters turn liquid CO₂ into dry ice pellets that remove paint, grease, and dirt—without releasing harmful abrasive media into the surrounding air. Since the pellets turn to gas on contact, there's no media left behind to clean up.

Ideal for light surface prep on metals, the dry ice pellets won't scratch or etch your material. Adjust the pressure and spray width for small or large surfaces, and fine-tune your settings in real time using feedback from the display. Do a test run before using these blasters on soft plastics, since the pellets may leave behind a texture. Opt for a blasting setup with conventional media for tough removal of heavy coatings, corrosion, or scale.

You don't need to order pellets to get started. The built-in pelletizer converts liquid CO₂ into blasting media as you work. Connect a 50 lb. or 75 lb. CO₂ tank with siphon tubes (sold separately). The system draws CO₂ only when you pull the trigger, so quick jobs won't drain your tank. Any unused CO₂ can be stored for later jobs. Set these blasters up in any well-ventilated space.

Use this thick gel to remove rust from vertical surfaces. Removers are acid free and are safe for contact with skin and sensitive surfaces, such as copper, brass, aluminum, and plastic. They’re low odor and contain no VOCs, so they can be used in enclosed and occupied areas. Brush them onto rusty surfaces; after an hour or two, rinse the rust and removers away with water.

These acid-free rust removers are safe for contact with people and surfaces. Dip, brush, or spray metal to remove and prevent rust. To use as a remover, rinse after applying; to use as an inhibitor, apply again and allow remover to dry on the item—removers prevent rust for up to four weeks.

One gallon removes _1/2 pound of pure rust, enough to treat 300 pounds of moderately corroded steel.