Drill and ream holes for taper pins with the same tool. These tools have chip breakers on the cutting edge.

Drill, enlarge, and finish a wide range of hole sizes in seconds with just three bits. Made with an oversized shank and hardened high-speed steel, the bits in these sets are built to handle the high torque of your impact wrench without snapping. A built-in pilot has a stepped tip that bites material immediately, centers the tool, and prevents slipping. The steps on the bit have progressively larger diameters—the deeper you drill, the bigger the hole. Count the steps as you drill to achieve the proper size. Like a reamer, these bits leave a smooth, precise hole at each step. If you’re drilling to the bit’s maximum diameter, a safety collar stops the bit at that size. Since these bits deburr as they cut, they’re often used for thin workpieces, such as sheet metal and plastic panels.

You’ll need a VersaDrive chuck (sold separately) to install these bits into your impact wrench. You can also get chucks for impact drivers and magnetic-base drills (both sold separately). For jobs that don’t require the torque of an impact tool, you can fit these bits directly into a _1/2" chuck on a standard power drill.

With everything but the impact wrench, these sets are the fastest way to prepare holes with a hand tool. They include a selection of cutting tools and a chuck that lets you swap them in and out of your impact wrench. Made with hardened steel, the cutting tools are built to handle the high torque of the wrench without snapping, even in hard metals. This also means the bits cut holes two times faster than with a power drill, and the taps thread holes 15 times faster than with a tap wrench. The rapid hammering breaks and clears chips as you work to prevent jams. Since your wrench absorbs kickback, it won’t fight you if a cutting tool snags, reducing wrist strain and fatigue over long jobs.

The chucks hold any tool with a VersaDrive hex shank—including countersinks and extractors—so just one chuck and wrench handle any cutting task.

Drill, enlarge, and finish holes in seconds with these all-in-one tools. Made with an oversized shank and hardened high-speed steel, these bits are built to handle the high torque of your impact wrench without snapping. A built-in pilot has a stepped tip that bites material immediately, centers the tool, and prevents slipping. The steps on the bit have progressively larger diameters—the deeper you drill, the bigger the hole. Count the steps as you drill to achieve the proper size. Like a reamer, these bits leave a smooth, precise hole at each step. If you’re drilling to the bit’s maximum diameter, a safety collar stops the bit at that size. Since these bits deburr as they cut, they’re often used for thin workpieces, such as sheet metal and plastic panels.

You’ll need a VersaDrive chuck (sold separately) to install these bits into your impact wrench. You can also get chucks for impact drivers and magnetic-base drills (both sold separately). For jobs that don’t require the torque of an impact tool, you can fit these bits directly into a _1/2" chuck on a standard power drill.