More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Keep fixtures solidly in place—these anchors have two locking wedges that won't shake loose.

These 18-8 stainless steel anchors have good chemical resistance.

An open-end cap nut provides a finished appearance.

These 18-8 stainless steel anchors have good chemical resistance.

Drive these tools with a hammer until the thicker portion of the tool makes contact with the anchor, causing it to expand.

A zinc plating provides corrosion resistance in wet environments.

Often referred to as four-way expansion anchors, these expand in four directions to resist loosening from vibration.

Drive these tools with a hammer to expand anchors.

The fastest way to install shallow-hole female-threaded anchors. Just push the tip of the tool into the anchor and turn the tool with a power drill.

A zinc plating provides corrosion resistance in wet environments.

A tamper-resistant nut prevents unwanted removal of the object you are anchoring.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

Bolts are beveled under the head for a flush finish in countersunk holes.

18-8 stainless steel anchors have good chemical resistance.

These steel anchors are available with corrosion-resistant finishes.

A pivoting toggle bar creates a strong hold.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

Attach the components of these sets onto a hammer drill to install tapping screws in concrete, block, and brick.

Permanently set threaded rods, studs, and rebar in concrete.

When concrete is saturated or submerged in water, use these adhesives to form strong bonds.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

Drill holes up to 1 1/2" in diameter.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

A built-in stop ensures repeatable drilling depths for installing drop-in anchors.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

A more controlled chip removal reduces heat buildup. Use these bits on brittle materials such as block and brick.