Carry loads along a track with this series of smooth rolling alternating vertical and horizontal wheels. Use a carrier to attach your load to the chain. Vertical wheel axles spaced every 8" serve as attachment points for carriers. Note: Weight capacity listed is per attachment point.

These rods have a bracket on the base so they're ready to mount.

Use brackets to hang and join sections of enclosed track. They have a hole in the top for hanging from threaded rod.

Take the guesswork out of precisely aligning a conveyor guide—these mounts have graduations every 1 mm. They come assembled but can be easily adapted by swapping, adding, or adjusting parts. These mounts work with both round and square mounting rods. Move the mount closer to or farther from your setup using the included rod with a bracket base. They also come with two adjustable handles, often called clamping handles, so it’s easy to frequently change the mount’s position and tighten the rods without tools. Lift the handle to rotate it into an ergonomic position or move it out of the way. Release the handle to tighten or loosen components.

To modify these mounts, add mounting rods, mounting rods with a clamp, mounting rods with a bracket base, mounting rod end caps, mounting rod connectors, mounting rod brackets, and adjustable handles. Use the included hex key to fasten or remove parts.

To install these mounts to a magnetic surface, attach a magnetic base (sold separately).

Swap out, add, or adjust components on these mounts to get your conveyor guide exactly where you need it. They come assembled but are easy to reconfigure. These mounts work with both round and square mounting rods. Move the mount closer to or farther from your setup using the included rod with a bracket base. They also come with two adjustable handles, often called clamping handles, so it’s easy to frequently change the mount’s position and tighten the rods without tools. Lift the handle to rotate it into an ergonomic position or move it out of the way. Release the handle to tighten or loosen components.

To modify these mounts, add mounting rods, mounting rods with a clamp, mounting rods with a bracket base, mounting rod end caps, mounting rod connectors, mounting rod brackets, and adjustable handles. Use the included hex key to fasten or remove parts.

To install these mounts to a magnetic surface, attach a magnetic base (sold separately).

Push to move material along the conveyor.

Height is measured from the bottom of the track to the center of the connection holes.

Prevent excess wear on the track and trolley—only the wheels of these push trolleys come in contact with the beam. Trolleys can be installed anywhere along the beam.

Use with conveying chain to automatically move these trolleys along the beam. The two-bolt bottom connection keeps the trolleys from loosening during use.