Skip a step when installing screws of various thread diameters in metal. With a sharp point on the tip, these counterbores drill a pilot hole topped with a flat recess for the screw head. That's faster and more accurate than switching to a counterbore in between passes with your drill bit.

Create flat, close-fitting recesses for a range of screw-head sizes. The pilot centers and stabilizes the counterbore for an accurate cut and even surface on the first try.

These counterbores are often used when screw holes in sheets or layers are misaligned. Also known as subland drill bits, they last longer than standard counterbore drill bits because the diameter stays the same after sharpening. They drill and counterbore at the same time. After drilling and counterboring, tap the hole and install your fastener. The diameters account for the _1/32” or _1/64” oversized diameter rating.

Often called step drill bits, these cut a pilot hole and counterbore in a single pass to eliminate tool changes and ensure precise alignment. Made of high-speed steel, they handle a wide range of materials, including aluminum, plastic, and stainless steel. They can be resharpened to extend tool life. The body diameter may decrease after multiple sharpenings.

Designed to give screw heads a slightly loose fit, these counterbores are a bit wider than standard sizes. The extra clearance prevents binding and leaves room for a seal or O-ring around the screw head.

Also known as subland drill bits, these last longer than standard counterbore drill bits because the diameter stays the same after sharpening. They drill and counterbore at the same time. After drilling and counterboring, tap the hole and install your fastener.

Create a smoother, more accurate finish than you can with solid-body countersink drill bits. Since these bits are hollow, they remove chips and make less contact as they cut to minimize friction and vibration. Also known as step drill bits, they countersink as they drill. The 82° countersink angle is compatible with the profile of flat- and oval-head inch screws.

Center holes perfectly before installing hinges, latches, and other hardware that require a countersunk screw. These bits have a built-in guide with a beveled tip that keeps the bit in position as it enters the material. So instead of measuring and marking, use your hardware as a template to drill the pilot holes. Once screws are installed, they're straight and the heads are flush. Also known as Vix bits, they're made of wear- and heat-resistant high-speed steel.