18-8 stainless steel screws have good chemical resistance.

Stronger and more wear resistant than 18-8 and 316 stainless steel, these screws are mildly chemical resistant.

These square-drive screws are beveled under the head for use in countersunk holes.

18-8 stainless steel screws have good chemical resistance.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Install and remove these screws with a tamper-resistant spanner driver.

Made from 18-8 stainless steel, these screws are chemical resistant.

Made from stainless steel, these screws are more corrosion resistant than steel, and almost as strong.

With a drilling tip, these metric screws cut their own pilot hole and threads as you fasten them into material.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.

Made from 410 stainless steel, these screws are strong, wear resistant, and mildly chemical resistant.

18-8 stainless steel screws have good chemical resistance.

These screws are beveled under the head for use in countersunk holes.

18-8 stainless steel screws have good chemical resistance.

Beveled under the head for use in countersunk holes, these steel screws press threads into material for a tight, secure hold.

These steel screws are zinc plated to resist corrosion in wet environments.

Brass screws are corrosion resistant in wet environments and electrically conductive.

A decorative rounded top provides a finished appearance. These Phillips screws are beveled under the head for use in countersunk holes. They press threads into material for a tight, secure hold.

These screws speed installation by drilling, tapping, and fastening wood and metal in a single operation.

A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.

18-8 stainless steel screws have good chemical resistance.

Also known as deck screws, these Phillips screws have a sharp point and narrow body to penetrate softwood and plastic-wood composite decking material.

18-8 stainless steel screws have good chemical resistance.

Because these steel screws cut threads into drilled holes as they’re turned, they require less driving torque and cause less stress on material than thread-forming screws. Also known as trim-head deck screws, they have a small flat head and slender shank to reduce the risk of splitting boards.

These steel screws are zinc plated to resist corrosion in wet environments.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

Power through drywall and into metal studs up to 0.105" thick.

Alternating high and low threads minimize driving torque and allow the screw to hold more material between threads for a stronger hold and better strip-resistance than standard drywall screws for wood.

Hang drywall to wood framing. These screws have a sharp point that penetrates drywall and a curved neck that sinks in without tearing the paper surface.

Hold sheets of drywall together until glue sets

A drill point powers through drywall and into metal studs up to 0.105" thick. Heads are one-third smaller than those of other drywall screws.