Grab a locker and set your own code—no keys or combinations to track. The keypad lock on these lockers resets each time you unlock them, just like your gym locker. They're useful in busy spaces where people on different shifts share lockers. You can also program them with a permanent code if one person uses the same locker each day. Each locker can be accessed with a master code. LEDs flash when batteries are low, and the lock stays secure if the batteries die.

These lockers come assembled. For more stability, anchor them to the wall or floor through the mounting holes.

Remotely open your enclosure door with a card reader, manual release button, or other access control device. These locks have a switch that opens the lock when it receives power from your access system. They can also trigger a light, alarm, or other device to let you know when the lock is open or closed. Closing the door resets the switch. In case of emergency, these locks manually open with a key.

Often installed on server cabinets and electrical panels, these locks have a handle that swings smoothly when you lift it to latch and unlatch the door. The handle lies flat when locked, which means it won’t snag anything that passes by.

Open with either a key fob or your Bluetooth-enabled smartphone. Download the lock’s corresponding app to register the lock and control it. Through the app, you can add or remove users, set a schedule for when they have access, and track activity. You can also give short-term access to temporary users, such as contractors or inspectors. All padlocks are battery operated and alert you when the battery is low. If the battery dies, these padlocks remain locked until the power is restored. Use the USB-C port on the bottom of the lock to recharge the battery.

Gain access from the outside with a combination; the inside handle is always unlocked. These handles are mechanical and do not require electrical wiring or batteries. They are UL Listed for use with three-hour fire doors.

To determine door swing direction, stand on the side of the door where it swings away from you. If it opens to the right, select a right handle; if it opens to the left, select a left handle. Select a handle with the correct backset distance (the distance from the door’s edge to the center of the handle's mounting hole) for your door. Latch bolt projection is the length the latch bolt extends from the door's edge.

Check contents without unlocking these lockers—clear doors make everything inside visible. They come assembled. For more stability, anchor them to the wall or floor through the mounting holes.

Wire multiple components in your security system using a single cable. This cable bundles together four color-coded cables that correspond to each part of an access point: the card reader, the door contact, the lock, and the exit sign. Each interior cable is labeled with the component it matches. All four interior cables have a layer of foil around them to prevent signal interference from nearby devices. Designated CMP, it has a flame-resistant, low-smoke insulation and can be used without conduit in duct work and above a drop ceiling. It’s also known as plenum cable. It’s rated FT6, so it meets requirements for preventing the spread of flames and smoke based on a timed test with material mounted to a horizontal tray.